Search results
Results from the WOW.Com Content Network
A birds-mouth joint in a rafter, set upon a double top plate. Shown are the two cuts of the joint: the seat cut and the heel cut. In light frame construction, a birdsmouth joint or bird's beak cut is a woodworking joint that is generally used to connect a roof rafter to the top plate of a supporting wall. [1]
Among its basic uses are marking common, hip, valley and hip, or valley jack rafters, laying out stair stringers, determining and marking angles, and making square cuts on boards. Common lines made using a speed square include perpendicular cut marks and Angles definition of an angle for roofs, stairways, and decks. The tool uses a 0° reference.
A lookout, [1] lookout rafter or roof outlooker [2] is a wooden joist that extends in cantilever out from the exterior wall (or wall plate) of a building, supporting the roof sheathing and providing a nailing surface for the fascia boards. When not exposed it serves to fasten the finish materials of the eaves.
Compass rafter: A rafter curved or bowed on the top (the top surface of a rafter is called its "back") or both the top and bottom surfaces. Curb rafter: The upper rafters in a curb (kerb, gambrel, Mansard roof) roof. Hip rafter (angle rafter): The rafter in the corners of a hip roof. The foot of a hip rafter lands on a dragon beam.
This is an accepted version of this page This is the latest accepted revision, reviewed on 28 January 2025. American multinational home improvement supplies retailing company The Home Depot, Inc. An aerial view of a Home Depot in Onalaska, Wisconsin Company type Public Traded as NYSE: HD DJIA component S&P 100 component S&P 500 component Industry Retail (home improvement) Founded February 6 ...
Typically the knee wall is covered with plaster or gypsum board. The term is derived from the association with a human knee, partly bent. Knee walls are common in houses in which the ceiling on the top floor is an attic , i.e. the ceiling is the underside of the roof and slopes down on one or more sides.
By supporting the rafters they allow longer spans than the rafters alone could span, thus allowing a wider building. Purlin plates are very commonly found in large old barns in North America. A crown plate has similarities to a purlin plate but supports collar beams in the middle of a timber-framed building.
Masonite board Back side of a masonite board Isorel, c. 1920 Quartrboard, [1] Masonite Corporation, c. 1930. Masonite, also called Quartboard or pressboard, [2] is a type of engineered wood made of steam-cooked and pressure-molded wood or paper fibers. The fibers form a stiff, dense material in a range of weights. [3]