Search results
Results from the WOW.Com Content Network
For example, Albany, New York is roughly 140 miles north of New York City. Every site on Earth has a unique absolute location, which can be identified with a reference grid (such as latitude and longitude). Maps and globes can be used to find location and can also be used to convey other types of geographical information.
Also amphidrome and tidal node. A geographical location where there is little or no tide, i.e. where the tidal amplitude is zero or nearly zero because the height of sea level does not change appreciably over time (meaning there is no high tide or low tide), and around which a tidal crest circulates once per tidal period (approximately every 12 hours). Tidal amplitude increases, though not ...
These letters form the third and fourth characters of a full GEOREF coordinate. Four letters thus identify any 1-degree quadrangle in the world. Each of the 1-degree quadrangles is further subdivided into 60 1-minute longitude zones, numbered 00 through 59 from west to east, and 60 1-minute latitude bands, numbered 00 to 59 from south to north.
An alphanumeric grid (also known as atlas grid [1]) is a simple coordinate system on a grid in which each cell is identified by a combination of a letter and a number. [2]An advantage over numeric coordinates such as easting and northing, which use two numbers instead of a number and a letter to refer to a grid cell, is that there can be no confusion over which coordinate refers to which ...
The second digit (x0xx through x8xx) indicates the number of tens of degrees latitude (north in global quadrants 1 and 7, south in global quadrants 3 and 5) of the 'minimum' square boundary (nearest to the Equator), i.e. a cell extending between 10°N and 20°N (or 10°S and 20°S) has this digit = 1, a cell extending between 20°N and 30°N ...
Since, in the UK at least, a 6-figure grid reference identifies a square of 100-metre sides, an 8-figure reference would identify a 10-metre square, and a 10-digit reference a 1-metre square. In order to give a standard 6-figure grid reference from a 10-figure GPS readout, the 4th, 5th, 9th and 10th digits must be omitted, so it is important ...
Geodetic latitude and geocentric latitude have different definitions. Geodetic latitude is defined as the angle between the equatorial plane and the surface normal at a point on the ellipsoid, whereas geocentric latitude is defined as the angle between the equatorial plane and a radial line connecting the centre of the ellipsoid to a point on the surface (see figure).
The intersection of a UTM zone and a latitude band is (normally) a 6° × 8° polygon called a grid zone, whose designation in MGRS is formed by the zone number (one or two digits – the number for zones 1 to 9 is just a single digit, according to the example in DMA TM 8358.1, Section 3-2, [1] Figure 7), followed by the latitude band letter ...