Ad
related to: peltier device as a generator for sale by owner
Search results
Results from the WOW.Com Content Network
Thermoelectric cooling uses the Peltier effect to create a heat flux at the junction of two different types of materials. A Peltier cooler, heater, or thermoelectric heat pump is a solid-state active heat pump which transfers heat from one side of the device to the other, with consumption of electrical energy, depending on the direction of the current.
A thermoelectric generator (TEG), also called a Seebeck generator, is a solid state device that converts heat (driven by temperature differences) directly into electrical energy through a phenomenon called the Seebeck effect [1] (a form of thermoelectric effect).
An automotive thermoelectric generator (ATEG) is a device that converts some of the waste heat of an internal combustion engine (IC) into electricity using the Seebeck Effect. A typical ATEG consists of four main elements: A hot-side heat exchanger , a cold-side heat exchanger, thermoelectric materials , and a compression assembly system.
The Peltier effect can be considered as the back-action counterpart to the Seebeck effect (analogous to the back-EMF in magnetic induction): if a simple thermoelectric circuit is closed, then the Seebeck effect will drive a current, which in turn (by the Peltier effect) will always transfer heat from the hot to the cold junction.
The symmetrical Peltier effect (Jean Charles Athanse Peltier, 1785–1845) uses an electric current to produce temperature differences. In the middle part of the twentieth century the thermo-electric generator was often used in place of galvanic batteries .
The efficiency of a thermoelectric device for electricity generation is given by , defined as =.. The maximum efficiency of a thermoelectric device is typically described in terms of its device figure of merit where the maximum device efficiency is approximately given by [7] = + ¯ + ¯ +, where is the fixed temperature at the hot junction, is the fixed temperature at the surface being cooled ...
The fluid has a lower boiling point than water to allow it to boil at low temperature, to form a superheated gas that can drive the blade of a turbine and thus a generator. Thermoelectric (Seebeck, Peltier, Thomson effects) units may also be called WHRU, since they use the heat differential between two plates to produce direct current (DC) power.
The multi-mission radioisotope thermoelectric generator of Mars Science Laboratory. Curiosity, the MSL rover that was successfully landed in Gale Crater on August 6, 2012, uses one MMRTG to supply heat and electricity for its components and science instruments. Reliable power from the MMRTG will allow it to operate for several years. [2]
Ad
related to: peltier device as a generator for sale by owner