enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Potentiometer - Wikipedia

   en.wikipedia.org/wiki/Potentiometer

   The 'log pot', that is, a potentiometer has a resistance, taper, or, "curve" (or law) of a logarithmic (log) form, is used as the volume control in audio power amplifiers, where it is also called an "audio taper pot", because the amplitude response of the human ear is approximately logarithmic. It ensures that on a volume control marked 0 to 10 ...

3. Light-emitting diode physics - Wikipedia

   en.wikipedia.org/wiki/Light-emitting_diode_physics

   LED development began with infrared and red devices made with gallium arsenide. Advances in materials science have enabled making devices with ever-shorter wavelengths, emitting light in a variety of colors. LEDs are usually built on an n-type substrate, with an electrode attached to the p-type layer deposited on its surface.

4. Light-emitting diode - Wikipedia

   en.wikipedia.org/wiki/Light-emitting_diode

   Data sent to the first LED of the chain can control the brightness and color of each LED independently of the others. They are used where a combination of maximum control and minimum visible electronics are needed such as strings for Christmas and LED matrices. Some even have refresh rates in the kHz range, allowing for basic video applications.

5. LED circuit - Wikipedia

   en.wikipedia.org/wiki/LED_circuit

   Many circuits operate LEDs at less than the specified maximum current to save power, or to reduce brightness, or to use a common resistor value. For indoor use, tiny surface mount high-efficiency LEDs can easily light up with 1 mA (0.001 A) or more current, which most digital logic outputs can easily source or sink.

6. Digital potentiometer - Wikipedia

   en.wikipedia.org/wiki/Digital_potentiometer

   While quite similar to normal potentiometers, digital potentiometers are constrained by current limit in the range of tens of milliamperes. Also, most digital potentiometers limit the voltage range on the two input terminals (of the resistor) to the digital supply range (e.g. 0–5 VDC), so additional circuitry may be required to replace a conventional potentiometer, (although digital ...

7. Lighting control system - Wikipedia

   en.wikipedia.org/wiki/Lighting_control_system

   A lighting control system is intelligent network-based lighting control that incorporates communication between various system inputs and outputs related to lighting control with the use of one or more central computing devices. Lighting control systems are widely used on both indoor and outdoor lighting of commercial, industrial, and ...

8. TFT LCD - Wikipedia

   en.wikipedia.org/wiki/TFT_LCD

   Backlight intensity is usually controlled by varying a few volts DC, or generating a PWM signal, or adjusting a potentiometer or simply fixed. This in turn controls a high-voltage (1.3 kV) DC-AC inverter or a matrix of LEDs. The method to control the intensity of LED is to pulse them with PWM which can be source of harmonic flicker. [citation ...

9. Pulse-width modulation - Wikipedia

   en.wikipedia.org/wiki/Pulse-width_modulation

   Adjusting the brightness of light emitted by a light source is then merely a matter of setting at what voltage (or phase) in the AC half-cycle the dimmer begins to provide electric current to the light source (e.g. by using an electronic switch such as a triac). In this case the PWM duty cycle is the ratio of the conduction time to the duration ...