Search results
Results from the WOW.Com Content Network
Torque charts are available to specify the required torque for a given fastener based on its property class (fineness of manufacture and fit) and grade (tensile strength). Spring Analogy for a Bolted Joint. When a fastener is tightened, a tension preload is develops in the bolt, while an equal compressive preload forms in the clamped parts.
torque-angle tightening (also known as torque-angle tension control) is a method of securing the bolted joint when the initial tension is critical for reliability and safety. The technique relies on simultaneous monitoring of both the torque applied during the tightening as well as the angle of rotation, usually using a torque/angle wrench.
Torsion of a square section bar Example of torsion mechanics. In the field of solid mechanics, torsion is the twisting of an object due to an applied torque [1] [2].Torsion could be defined as strain [3] [4] or angular deformation [5], and is measured by the angle a chosen section is rotated from its equilibrium position [6].
In 1820, the French engineer A. Duleau derived analytically that the torsion constant of a beam is identical to the second moment of area normal to the section J zz, which has an exact analytic equation, by assuming that a plane section before twisting remains planar after twisting, and a diameter remains a straight line.
In physics and mechanics, torque is the rotational analogue of linear force. [1] It is also referred to as the moment of force (also abbreviated to moment). The symbol for torque is typically , the lowercase Greek letter tau. When being referred to as moment of force, it is commonly denoted by M.
Multi-jackbolt tensioners (MJTs), registered under the trademark Superbolt or Supernut, are designed to decrease the torque required to tighten large bolted joints. One of the major problems associated with traditional bolt tightening methods is as the diameter of the bolt increases, the amount of torque required to tighten it increases in the third power of the diameter. [1]
The torque applied to the fastener must be determined such that it does not contribute to a service condition where the fastener enters a low-cycle fatigue regime. In general, the use of torque-to-yield fasteners is deprecated except in cases where the materials and structures comprising the entire assembly are certified to be within tolerances ...
The torque is then related to the lever length, shaft diameter and measured force. The device is generally used over a range of engine speeds to obtain power and torque curves for the engine, since there is a non-linear relationship between torque and engine speed for most engine types. Power output in SI units may be calculated as follows: