Ad
related to: what is vlan configuration recommendations for internettechtarget.com has been visited by 100K+ users in the past month
Search results
Results from the WOW.Com Content Network
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
A VLAN can also serve to restrict access to network resources without regard to physical topology of the network. [a] VLANs operate at the data link layer of the OSI model. Administrators often configure a VLAN to map directly to an IP network, or subnet, which gives the appearance of involving the network layer.
Cisco Inter-Switch Link (ISL) is a Cisco proprietary link layer protocol that maintains VLAN information in Ethernet frames as traffic flows between switches and routers, or switches and switches. [1] ISL is Cisco's VLAN encapsulation protocol and is supported only on some Cisco equipment over the Fast and Gigabit Ethernet links.
While private VLANs provide isolation between peers at the data link layer, communication at higher layers may still be possible depending on further network configuration. A typical application for a private VLAN is a hotel or Ethernet to the home network where each room or apartment has a port for Internet access.
This is known as inter-VLAN routing. On layer-3 switches it is accomplished by the creation of layer-3 interfaces (SVIs). Inter VLAN routing, in other words routing between VLANs, can be achieved using SVIs. [1] SVI or VLAN interface, is a virtual routed interface that connects a VLAN on the device to the Layer 3 router engine on the same device.
This way the service provider can just configure one VLAN for the customer and the customer can then treat that VLAN as if it were a trunk. IEEE 802.1ad was created for the following reasons: 802.1Q has a 12-bit VLAN ID field, which has a limit of 2 12 (4096) tags. With the growth of networks, this limitation has become more acute.
Within a layer 2 network, MVRP provides a method to dynamically share VLAN information and configure the needed VLANs. For example, in order to add a switch port to a VLAN, only the end port, or the VLAN-supporting network device connected to the switch port need be reconfigured, and all necessary VLAN trunks are dynamically created on the ...
On Cisco Devices, VTP (VLAN Trunking Protocol) maintains VLAN configuration consistency across a single Layer 2 network. VTP uses Layer 2 frames to manage the addition, deletion, and renaming of VLANs from switches in the VTP client mode. VTP is responsible for synchronizing VLAN information within a VTP domain and reduces the need to configure ...
Ad
related to: what is vlan configuration recommendations for internettechtarget.com has been visited by 100K+ users in the past month