enow.com Web Search

  1. Ads

    related to: toilet seat standard dimensions chart size 1 10 gallon

Search results

  1. Results from the WOW.Com Content Network
  2. Toilet seat - Wikipedia

    en.wikipedia.org/wiki/Toilet_seat

    A toilet seat is a hinged unit consisting of a round or oval open seat, and usually a lid, which is bolted onto the bowl of a toilet used in a sitting position (as opposed to a squat toilet). The seat can be either for a flush toilet or a dry toilet .

  3. Flush toilet - Wikipedia

    en.wikipedia.org/wiki/Flush_toilet

    If the toilet is flushed from a tank, a large holding cistern is mounted above the toilet, containing approximately 4.5 to 6 L (1.2 to 1.6 US gallons) of water in modern designs. This tank is built with a large drain 50 to 75 mm (2 to 3 inches) diameter hole at its bottom covered by a flapper valve that allows the water to rapidly leave the ...

  4. Toilet - Wikipedia

    en.wikipedia.org/wiki/Toilet

    A toilet [n 1] is a piece of sanitary hardware that collects human waste (urine and feces), and sometimes toilet paper, usually for disposal. Flush toilets use water, while dry or non-flush toilets do not.

  5. Low-flush toilet - Wikipedia

    en.wikipedia.org/wiki/Low-flush_toilet

    A low-flush toilet (or low-flow toilet or high-efficiency toilet) is a flush toilet that uses significantly less water than traditional high-flow toilets. Before the early 1990s in the United States, standard flush toilets typically required at least 3.5 gallons (13.2 litres) per flush and they used float valves that often leaked, increasing their total water use.

  6. Accessible toilet - Wikipedia

    en.wikipedia.org/wiki/Accessible_toilet

    According to ADA the height of toilet bowl shall be 17 inches (430 mm) at a minimum when measured from the floor to the top of the toilet seat. Flush controls shall be hand operated or automatic mounted on the wide side of the toilet area and easily reached and operated.

  7. Fixture unit - Wikipedia

    en.wikipedia.org/wiki/Fixture_unit

    A Fixture Unit is not a flow rate unit but a design factor. A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste ...

  1. Ads

    related to: toilet seat standard dimensions chart size 1 10 gallon