Search results
Results from the WOW.Com Content Network
In a home or small office environment, the default gateway is a device, such as a DSL router or cable router, that connects the local network to the Internet. It serves as the default gateway for all network devices. Enterprise network systems may require many internal network segments. A device wishing to communicate with a host on the public ...
On Windows computers, the gateway address is configured using the TCP/IP Properties. The gateway address can be automatically determined using Dynamic Host Configuration Protocol (DHCP). DHCP allows a host to obtain network information from a server. The host contacts the server to obtain an IP address and Default Gateway address.
The network with the longest subnet mask or network prefix that matches the destination IP address is the next-hop network gateway. The process repeats until a packet is delivered to the destination host, or earlier along the route, when a router has no default route available and cannot route the packet otherwise.
The IP forwarding algorithm is a specific implementation of routing for IP networks. In order to achieve a successful transfer of data, the algorithm uses a routing table to select a next-hop router as the next destination for a datagram. The IP address of the selected router is known as the next-hop address. [1] The IP forwarding algorithm ...
A router is considered a layer-3 device because its primary forwarding decision is based on the information in the layer-3 IP packet, specifically the destination IP address. When a router receives a packet, it searches its routing table to find the best match between the destination IP address of the packet and one of the addresses in the ...
The primary function of a router is to forward a packet toward its destination network, which is the destination IP address of the packet. To do this, a router needs to search the routing information stored in its routing table. The routing table contains network/next hop associations. These associations tell a router that a particular ...
NOTE: a RID is the highest logical (loopback) IP address configured on a router, if no logical/loopback IP address is set then the router uses the highest IP address configured on its active interfaces (e.g. 192.168.0.1 would be higher than 10.1.1.2). Usually the router with the second-highest priority number becomes the BDR.
This address is used by only one physical router at a time, and it will reply with this MAC address when an ARP request is sent for the virtual router's IP address. Physical routers within the virtual router must communicate within themselves using packets with multicast IP address 224.0.0.18 and IP protocol number 112 [1] for IPv4, or ff02::12 ...