Search results
Results from the WOW.Com Content Network
Use of electronic test equipment is essential to any serious work on electronics systems. Practical electronics engineering and assembly requires the use of many different kinds of electronic test equipment ranging from the very simple and inexpensive (such as a test light consisting of just a light bulb and a test lead) to extremely complex ...
The first ten transceivers Swan produced were serial numbered from 101-1 to 110-1, with the first nine being model SW-120 operating on 20 meters (14 MHz), and the tenth, 110-1, being the first SW-140, operating on 40 meters (7 MHz). The SW-175 then covered the 75 meter band (3.8 MHz).
In electrical engineering, characteristics like current or voltage can be measured by an ammeter, a voltmeter, a multimeter, etc.The ammeter is used in series with the load, so the same current flows through the load and the ammeter.
Electrical power by the means of electricity meter; S-matrix by the means of network analyzer (electrical) Electrical power spectrum by the means of spectrum analyzer; Measurable dependent electrical quantities comprise: Inductance; Capacitance; Electrical impedance defined as vector sum of electrical resistance and electrical reactance
Typically, a signal ranged from 3 to 15 psi (20 to 100kPa or 0.2 to 1.0 kg/cm2) as a standard, was standardized with 6 to 30 psi occasionally being used for larger valves. Transistor electronics enabled wiring to replace pipes, initially with a range of 20 to 100mA at up to 90V for loop powered devices, reducing to 4 to 20mA at 12 to 24V in ...
K.W. Electronics was a British manufacturer of amateur radio equipment founded in the mid-1950s by the late Rowley Shears G8KW. It was based in Dartford , Kent , and manufactured a wide range of high frequency band receivers, transmitters and accessory equipment.
A much more modern and sophisticated device than earlier CD meters and equipped with a probe containing two Geiger-Mueller tubes of differing sensitivities, the CD V-718 can cover a much wider range of radiation levels than the earlier Geiger counters and ion-chamber survey meters combined (from .001mR/h to 10,000 R/h).
Consequently, a one-meter high-impedance direct (1×) coaxial probe may load the circuit with a capacitance of about 110 pF and a resistance of 1 megohm. Oscilloscope probes are characterised by their frequency limit, where the amplitude response has fallen by 3 dB, and/or by their rise time t r {\displaystyle t_{r}} .