Search results
Results from the WOW.Com Content Network
This allows one to choose single-phase AC power at either 110–120 volts between phase and neutral or 220–240 volts between phase and phase. Since these two modes do not need three phases there is also a dark yellow-orange four-pin connector available designed for a single-phase 110–120 or 220–240 volt load.
A CCS1 (Combined Charging Standard 1) DC charging connector, which is used in North America. It is an extension of the J1772 standard AC charging connector. CCS Combo 1 vehicle inlet showing the J1772 and the two DC fast-charging pins Connectors: Combo 2 (left), compared to IEC Type 2 (right).
When AC power is used, the NACS system can deliver up to 80 amperes at 277 volts (a voltage derived from a three-phase commercial power supply at 480 volts). [ 2 ] [ 26 ] However, in a common configuration, NACS provides up to 48 amperes of current at 240 volts (the typical residential voltage of the North American split-phase electric power ...
Single-phase AC: 120 V 12 A 1.44 kW 13 hours This is the maximum continuous power available from a standard US/Canadian 120 V 15 A circuit Single-phase AC: 230 V 16 A 3.68 kW 5.1 hours This is the maximum continuous power available from a CEE 7/3 ("Schuko") receptacle on a 16 A rated circuit Single-phase AC: 240 V 30 A 7.20 kW 2.6 hours
This process led to the proposal of a new round connector design by Yazaki which allowed for an increased power delivery of up to 19.2 kW delivered via single phase 120–240 V AC at up to 80 amps. In 2008, CARB published a new standard that mandated the usage of the new connector beginning with the 2010 model year; [ 7 ] this was approved in 2012.
The maximum voltage rating of IEC 60309 connectors is 1000 V DC or AC; the maximum current rating is 800 A; and the maximum frequency 500 Hz. Plugs are available in P+N+E (unbalanced single phase with neutral), 2P+E (balanced single phase), 3P+E (3 phase without neutral), and 3P+N+E (three phase with neutral).
Voltages in this article are the nominal single-phase supply voltages, or split-phase supply voltages. Three-phase and industrial loads may have other voltages. All voltages are root mean square (RMS) voltage; the peak AC voltage is greater by a factor of 2 {\displaystyle {\sqrt {2}}} , and the peak-to-peak voltage greater by a factor of 2 2 ...
"A single switch may be used for the control of two socket-outlets located immediately adjacent to each other". (subject to the current rating of the switch to be at least equal to the (a) total current rating of the sockets concerned; or (b) the current rating of the overcurrent protection device concerned, whichever is the lesser value.) [9]