Search results
Results from the WOW.Com Content Network
Laurell Technologies WS-400 spin coater used to apply photoresist to the surface of a silicon wafer. Spin coating is a procedure used to deposit uniform thin films onto flat substrates. Usually a small amount of coating material in liquid form is applied on the center of the substrate, which is either spinning at low speed or not spinning at all.
Spin casting, also known as centrifugal rubber mold casting (CRMC), is a method of utilizing inertia to produce castings from a rubber mold. Typically, a disc-shaped mold is spun along its central axis at a set speed.
Slot-die coating is a non-contact coating method, in which the slot-die is typically held over the substrate at a height several times higher than the target wet film thickness. [23] The coating fluid transfers from the slot-die to the substrate via a fluid bridge that spans the air gap between the slot-die lips and substrate surface.
A spinning solution consisting of polymer and a volatile solvent is extruded through a spinneret into an evaporating chamber. A stream of hot air impinges on the jets of spinning solution emerging from the spinneret, evaporating the solvent, and solidifying the filaments.
Spin welding machines come in two different types an inertia welding machine, and a continuous drive machine. In general, one of the parts to be welded is clamped in place, while the other is rotated. [2] Spin welding machines consist of two tool fixtures; fixed tooling, and driven tooling.
Spin casting is a technique for constructing large parabolic mirrors by using the curved surface formed by a rotating liquid (e.g. in a rotating furnace). [1] It is distinct from the spin casting or centrifugal rubber mold casting (CRMC) technique used for casting metal or plastics.
Conformal coating is a protective, breathable coating of thin polymeric film applied to printed circuit boards (PCBs). Conformal coatings are typically applied with 25–250 μm [ 1 ] thickness on electronic circuitry to protect against moisture and other substances.
This makes them relatively expensive compared to other coating technologies. Unlike many other coating methods, they can however handle coatings with a very wide range of viscosities, from 1 to more than 50000 mPas, and are capable of producing extremely polished finishes on the coatings they apply. They have been produced in a variety of 3 ...