Search results
Results from the WOW.Com Content Network
AC contactor for pump application. A contactor is an electrically controlled switch used for switching an electrical power circuit. [1] A contactor is typically controlled by a circuit which has a much lower power level than the switched circuit, such as a 24-volt coil electromagnet controlling a 230-volt motor switch.
The contact breaker is operated by an engine-driven cam.On an engine with a distributor, the contact breaker can be found beneath the distributor cap.The position of the contact breaker is set so that it opens (and hence generates a spark) at exactly the optimum moment to ignite the fuel/air mixture.
The breaker points (called "Contact breaker" in the figure) are an electrical switch opened and closed by a cam on the distributor shaft. This is timed so the points are closed for the majority of the engine cycle, allowing current to flow through the ignition coil, and are opened momentarily when a spark is desired.
The extended lighting cycle usually ends when the vehicle's ignition has begun, or a gradual reduction in light emitted after a couple of minutes if the car is not started, called "theater" lighting. Interior lighting has been added on some vehicles at the bottom edge of the dashboard, illuminating the floor for front passengers, or underneath ...
A contactor is a heavy-duty relay with higher current ratings, [21] used for switching electric motors and lighting loads. Continuous current ratings for common contactors range from 10 amps to several hundred amps. High-current contacts are made with alloys containing silver.
Typical contact elements of an electromechanical relay or contactor. A “contact” is a pair of electrodes (typically, one moving; one stationary) designed to control electricity. Electromechanical switches, relays, and contactors “turn power on” when the moving electrode makes contact with the stationary electrode to carry current.
A magnetic starter has a contactor and an overload relay, which will open the control voltage to the starter coil if it detects an overload on a motor. [1] [2] The overload relay opens a set of contacts that are wired in series with the supply to the contactor feeding the motor. The characteristics of the heaters can be matched to the motor so ...
Motor control centers are usually used for low voltage three-phase alternating current motors from 208 V to 600 V. Medium-voltage motor control centers are made for large motors running at 2300 V to around 15000 V, using vacuum contactors for switching and with separate compartments for power switching and control.