Search results
Results from the WOW.Com Content Network
It is possible to also get a bad picture if the signal strength of the TV transmitter is too high. An attenuator inserted in the antenna lead-in wire may be used if the television receiver displays signs of overload in the RF front end. Strong out-of-band signals may also affect television reception and may require band-pass filters to reduce ...
A simulated example of severe ghosting in an analog TV broadcast. In television, a ghost is a replica of the transmitted image, offset in position, that is superimposed on top of the main image. It is often caused when a TV signal travels by two different paths to a receiving antenna, with a slight difference in timing. [1]
A broadcast signal intrusion is the hijacking of broadcast signals of radio, television stations, cable television broadcast feeds or satellite signals without permission or licence. Hijacking incidents have involved local TV and radio stations as well as cable and national networks.
Outdoor antennas provide up to a 15 dB gain in signal strength and 15-20 dB greater rejection of ghost signals in analog TV. [6] Combined with a signal increase of 14 dB due to height and 11 dB due to lack of attenuating building walls, an outdoor antenna can result in a signal strength increase of up to 40 dB at the TV receiver. [6]
Check if you can visit other sites with a different browser - If you can go to another site, the problem may be associated the browser you're using. If you don't have another browser, download a supported one for free. 2. Check the physical connection - A loose cable or cord can often be the cause of a connection problem. Make sure everything ...
Signal reception is invariably done via a superheterodyne receiver: the first stage is a tuner which selects a television channel and frequency-shifts it to a fixed intermediate frequency (IF). The signal amplifier performs amplification to the IF stages from the microvolt range to fractions of a volt.
Mismatch loss in transmission line theory is the amount of power expressed in decibels that will not be available on the output due to impedance mismatches and signal reflections. A transmission line that is properly terminated, that is, terminated with the same impedance as that of the characteristic impedance of the transmission line, will ...
In analogue TV broadcasting, the video signal modulates a carrier by a kind of amplitude modulation (VSB modulation or C3F). The modulation polarity is negative. That means that the higher the level of the video signal the lower the power of the RF signal. The lowest possible modulating signal during the synchrone interval yields 100% of the ...