Search results
Results from the WOW.Com Content Network
A radio transmitter or just transmitter is an electronic device which produces radio waves with an antenna. Radio waves are electromagnetic waves with frequencies between about 30 Hz and 300 GHz. The transmitter itself generates a radio frequency alternating current, which is applied to the antenna. When excited by this alternating current, the ...
The TR-1 is a superheterodyne receiver [2] [11] with four n-p-n germanium transistors and one diode. It contains a single transistor converter stage, followed by two intermediate-frequency amplifier stages. After detection, a single-transistor stage amplifies the audio frequency. All amplifier stages use common emitter amplifiers. Stages are ...
Common circuit diagram symbols (US ANSI symbols) An electronic symbol is a pictogram used to represent various electrical and electronic devices or functions, such as wires, batteries, resistors, and transistors, in a schematic diagram of an electrical or electronic circuit. These symbols are largely standardized internationally today, but may ...
The transistor both amplifies and rectifies the amplitude modulated (AM) radio signal. Since the base-emitter junction acts as a diode it conducts only on the positive half-cycles of the carrier wave, blocking the negative half cycles, rectifying the carrier to extract the audio modulation signal from the radio wave. The collector current is an ...
A circuit diagram (or: wiring diagram, electrical diagram, elementary diagram, electronic schematic) is a graphical representation of an electrical circuit. A pictorial circuit diagram uses simple images of components, while a schematic diagram shows the components and interconnections of the circuit using standardized symbolic representations.
For instance, if a radio wave passing a given location has a flux of 1 pW / m 2 (10 −12 Watts per square meter) and an antenna has an effective area of 12 m 2, then the antenna would deliver 12 pW of RF power to the receiver (30 microvolts RMS at 75 ohms). Since the receiving antenna is not equally sensitive to signals received from all ...
For many systems, the terminator is a resistor, with a value chosen to match the characteristic impedance of the transmission line and chosen to have acceptably low parasitic inductance and capacitance at the frequencies relevant to the system. Examples include 75-ohm resistors often used to terminate 75-ohm video transmission coaxial cables.
Figure 2.2. Graph of the ladder network shown in figure 2.1 with a four rung ladder assumed. Networks are commonly classified by the kind of electrical elements making them up. In a circuit diagram these element-kinds are specifically drawn, each with its own unique symbol. Resistive networks are one-element-kind networks, consisting only of R ...