enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Kerosene lamp - Wikipedia

    en.wikipedia.org/wiki/Kerosene_lamp

    The wick rides in between the inner and outer wick tubes; the inner wick tube (central draft tube) provides the "central draft" or draft that supplies air to the flame spreader. When the lamp is lit, the central draft tube supplies air to the flame spreader that spreads out the flame into a ring of fire and allows the lamp to burn cleanly.

  3. Driptorch - Wikipedia

    en.wikipedia.org/wiki/Driptorch

    The wick is ignited and allows the fire to be directed as needed. The spout and wick can be secured upside down inside the canister for storage or transport. Typically the fuel used is a mixture of gasoline and diesel with a ratio of 30% to 70% respectively, although, the amounts may need to be adjusted according to fuel and weather conditions. [1]

  4. Candle wick - Wikipedia

    en.wikipedia.org/wiki/Candle_wick

    Wick of a candle Candle wick in a candle. A candle wick or lamp wick is usually made of braided cotton that holds the flame of a candle or oil lamp. A candle wick works by capillary action, conveying ("wicking") the fuel to the flame. When the liquid fuel, typically melted candle wax, reaches the flame it then vaporizes and combusts.

  5. Betty lamp - Wikipedia

    en.wikipedia.org/wiki/Betty_lamp

    The Crusie lamp consists of two lamp pans, one above the other. Fuel drip from the upper lamp pan fell into the lower pan minimizing oil/grease mess below the lamp. In the evolution to the Betty lamp, replacing the upper lamp pan with a metal wick holder inside the lower pan reduces the amount of metal needed for the lamp.

  6. Desoldering - Wikipedia

    en.wikipedia.org/wiki/Desoldering

    Solder wick on a reel. Desoldering braid, also known as desoldering wick or solder wick, is finely braided 18 to 42 AWG copper wire coated with rosin flux, usually supplied on a roll. Solder wick, before use... and soaked with solder and residue. The end of a length of braid is placed over the soldered connections of a component being removed.

  7. Duramax V8 engine - Wikipedia

    en.wikipedia.org/wiki/Duramax_V8_engine

    The Duramax V8 engine is a family of 6.6-liter diesel V8 engines produced by DMAX, a wholly owned subsidiary of General Motors in Moraine, Ohio.The Duramax block and heads are supplied from reliable vendors of General Motors.

  8. Water-tube boiler - Wikipedia

    en.wikipedia.org/wiki/Water-tube_boiler

    Schematic diagram of a marine-type watertube boiler. A high pressure watertube boiler [1] (also spelled water-tube and water tube) is a type of boiler in which water circulates in tubes heated externally by fire.

  9. Heat pipe - Wikipedia

    en.wikipedia.org/wiki/Heat_pipe

    Diagram showing components and mechanism for a heat pipe containing a wick Heat pipes keep ground frozen and inhibit water transfer into the open pit during mining activities at Ekati Diamond Mine This 100 mm by 100 mm by 10 mm high thin flat heat pipe (heat spreader) animation was created using high resolution CFD analysis and shows temperature contoured flow trajectories, predicted using a ...