Search results
Results from the WOW.Com Content Network
Araldite adhesive is used to join together the two sections of carbon composite which make up the monocoque of the Lamborghini Aventador. The use of Araldite adhesive in architecture to bond thin joints of pre-cast concrete units was pioneered by Ove Arup in Coventry cathedral and the Sydney Opera House . [ 4 ]
The mixture sets in 4-6 hours and fully cures in up to 15 hours. It can be used as an adhesive, laminate, plug, filler, sealant, or electrical insulator and can be drilled, ground, tapped, machined, sanded, and painted when cured. J-B Kwik is a faster-curing two-part epoxy with medium-temperature resistance up to 300 °F (149 °C).
Understanding the temperature dependence of viscosity is important for many applications, for instance engineering lubricants that perform well under varying temperature conditions (such as in a car engine), since the performance of a lubricant depends in part on its viscosity.
The SI unit of absolute thermal resistance is kelvins per watt (K/W) or the equivalent degrees Celsius per watt (°C/W) – the two are the same since the intervals are equal: ΔT = 1 K = 1 °C. The thermal resistance of materials is of great interest to electronic engineers because most electrical components generate heat and need to be cooled.
Viscosity is a measure of a fluid's rate-dependent resistance to a change in shape or to movement of its neighboring portions relative to one another. [1] For liquids, it corresponds to the informal concept of thickness; for example, syrup has a higher viscosity than water. [2]
Too low a temperature can cause the polymeric adhesive to enter its glass state becoming very brittle and reducing adhesion. [14] Raising the temperature, on the other hand, causes the polymer to become more fluid and mobile. As the mobility increases, the polymer adhesion is reduced as the polymer starts to flow as opposed to adhere.
A temperature drop is often observed at the interface between the two surfaces in contact. This phenomenon is said to be a result of a thermal contact resistance existing between the contacting surfaces. Interfacial thermal resistance is a measure of an interface's resistance to thermal flow. This thermal resistance differs from contact ...
Temperature is sometimes increased in a step-wise fashion to control the rate of curing and prevent excessive heat build-up from the exothermic reaction. Hardeners which show only low or limited reactivity at ambient temperature, but which react with epoxy resins at elevated temperature are referred to as latent hardeners. When using latent ...