Search results
Results from the WOW.Com Content Network
To reduce the power losses in the 5 V supply, with the introduction of the Pentium 4 microprocessor, Intel changed the processor power supply to operate on +12 V, and added the separate four-pin P4 connector to the new ATX12V 1.0 standard to supply that power.
COM-HPC Size D PICMG: 2020 160 × 160 mm (6.3 × 6.3 in) Used in embedded systems. Requires a carrier board. Typically used for COM-HPC Server Type modules with 4x full size DIMM memory sockets. COM-HPC Size E PICMG: 2020 200 × 160 mm (7.9 × 6.3 in) Used in embedded systems. Requires a carrier board.
ATX power supplies generally have the dimensions of 150 × 86 × 140 mm (5.9 × 3.4 × 5.5 in), [22]: 23–24 with the width and height being the same as the preceding LPX (Low Profile eXtension) form factor (which are often incorrectly referred to as "AT" power supplies due to their ubiquitous use in later AT and Baby AT systems, even though ...
Additional to the traditional screw contacts the electrical connection between the module and other parts of the power electronic system can also be achieved by pin contacts (soldered onto a PCB), press-fit contacts pressed into PCB vias, spring contacts that inherently press on contact areas of a PCB or by pure pressure contact where corrosion-proof surface areas are directly pressed together ...
To allow for voltage drops, the voltage at the host port, hub port, and device are specified to be at least 4.75 V, 4.4 V, and 4.35 V respectively by USB 2.0 for low-power devices, [a] but must be at least 4.75 V at all locations for high-power [b] devices (however, high-power devices are required to operate as a low-powered device so that they ...
A power supply is an electrical device that supplies electric power to an electrical load. The main purpose of a power supply is to convert electric current from a source to the correct voltage, current, and frequency to power the load. As a result, power supplies are sometimes referred to as electric power converters. Some power supplies are ...
There is little evidence that the dimensions of these early racks were standardized. Telephone equipment racks (1923) The 19-inch rack format with rack-units of 1.75 inches (44.45 mm) was established as a standard by AT&T around 1922 in order to reduce the space required for repeater and termination equipment in a telephone company central office .
Inside a gaming case during gameplay. 360° photograph. A full tower case. Accessories shown include: a fan controller, a DVD burner, and a USB memory card reader.. Cases can come in many different sizes and shapes, which are usually determined by the form factor of the motherboard since it is physically the largest hardware component in most computers. Consequently, personal computer form ...