Search results
Results from the WOW.Com Content Network
Circuit components such as amplifiers can be tested using the two-tone method with a test setup like that shown in the figure. Two signal generators, set to two different frequencies F1 and F2, are fed into a power combiner through circulators. The combiner needs to have good isolation to prevent the signal from one generator being sent to the ...
Longer cable runs are possible due to this increased noise immunity and 6 dB extra headroom. At higher frequencies, the output impedance of the output amplifier can change, resulting in a small imbalance. When driven in differential mode by two identical amplifiers, this impedance change will be the same for both lines, and thus cancelled out. [1]
Basic LVDS circuit operation showing current flowing in a loop back to the driver and the resulting lower radiated emission (EMI) due to field coupling within the differential pair Low-voltage differential signaling ( LVDS ), also known as TIA/EIA-644 , is a technical standard that specifies electrical characteristics of a differential , serial ...
Amplifier and loudspeaker with two elements and crossover networks. Top: normal connection. Bottom: bi-wiring. Loudspeaker bi-wired using banana plugs. Bi-wiring is a means of connecting a loudspeaker to an audio amplifier, primarily used in hi-fi systems. Normally, there is one pair of connectors on a loudspeaker and a single cable (two ...
Open-circuit test – Open-circuit voltage – Open-circuit time constant method – Open-circuit voltage – Operational amplifier – Optical fiber – Optimal control – Oscillation – Oscilloscope – Oudin coil – Out of phase – Outline of electrical engineering – Overhead line – Oversampling – Overshoot (signal) – Overvoltage ...
In electrical engineering, an electrical isolation test is a direct current (DC) or alternating current (AC) resistance test that is performed on sub-systems of an electronic system to verify that a specified level of isolation resistance is met. Isolation testing may also be conducted between one or more electrical circuits of the same ...
A Tower Mounted Amplifier (TMA), or Mast Head Amplifier (MHA), is a low-noise amplifier (LNA) mounted as close as practical to the antenna in mobile masts or base transceiver stations. A TMA reduces the base transceiver station noise figure (NF) and therefore improves its overall sensitivity ; in other words the mobile mast is able to receive ...
A Class B push–pull output driver using a pair of complementary PNP and NPN bipolar junction transistors configured as emitter followers. A push–pull amplifier is a type of electronic circuit that uses a pair of active devices that alternately supply current to, or absorb current from, a connected load.