Search results
Results from the WOW.Com Content Network
The 8052 was an enhanced version of the original 8051 that featured 256 bytes of internal RAM instead of 128 bytes, 8 KB of ROM instead of 4 KB, and a third 16-bit timer. Most modern 8051-compatible microcontrollers include these features. The 8032 had these same features as the 8052 except it lacked internal ROM program memory.
Delay calculation is the term used in integrated circuit design for the calculation of the gate delay of a single logic gate and the wires attached to it. By contrast, static timing analysis computes the delays of entire paths, using delay calculation to determine the delay of each gate and wire.
A prescaler is an electronic counting circuit used to reduce a high frequency electrical signal to a lower frequency by integer division.The prescaler takes the basic timer clock frequency (which may be the CPU clock frequency or may be some higher or lower frequency) and divides it by some value before feeding it to the timer, according to how the prescaler register(s) are configured.
In electronics time-to-digital converters (TDCs) or time digitizers are devices commonly used to measure a time interval and convert it into digital (binary) output. In some cases [1] interpolating TDCs are also called time counters (TCs). TDCs are used to determine the time interval between two signal pulses (known as start and stop pulse).
SAB-C515-LN by Infineon is based on the 8051. The Infineon XC800 family is an 8-bit microcontroller family, first introduced in 2005, [1] with a dual cycle optimized 8051 "E-Warp" [2] [3] core. The XC800 family is divided into two categories, the A-Family for Automotive and the I-Family for Industrial and multi-market applications.
In a computer's central processing unit (CPU), the accumulator is a register in which intermediate arithmetic logic unit results are stored.. Without a register like an accumulator, it would be necessary to write the result of each calculation (addition, multiplication, shift, etc.) to cache or main memory, perhaps only to be read right back again for use in the next operation.
Delta time or delta timing is a concept used amongst programmers in relation to hardware and network responsiveness. [1] In graphics programming, the term is usually used for variably updating scenery based on the elapsed time since the game last updated, [2] (i.e. the previous "frame") which will vary depending on the speed of the computer, and how much work needs to be done in the program at ...
A typical kitchen timer. A timer or countdown timer is a type of clock that starts from a specified time duration and stops upon reaching 00:00. An example of a simple timer is an hourglass. Commonly, a timer triggers an alarm when it ends. A timer can be implemented through hardware or software.