enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Base course - Wikipedia

   en.wikipedia.org/wiki/Base_course

   Aggregate base (AB) is typically a mix of different sizes of crushed rock 20 mm or 3 ⁄ 4 in Aggregate Base, Class 2, is used in roadways and consists of rock particles of size 20 mm (3 ⁄ 4 in) and less. An aggregate is normally made from newly quarried rock, or it is sometimes allowed to be made from recycled asphalt concrete and/or ...

3. Paver base - Wikipedia

   en.wikipedia.org/wiki/Paver_base

   Paver base is a form of aggregate used in the construction of patios and walkways whose topmost layer consists of mortarless (or "dry-laid") pavers. The first layer in the construction of such a surface is called the subgrade —this is the layer of native material underneath the intended surface.

4. Subbase (pavement) - Wikipedia

   en.wikipedia.org/wiki/Subbase_(pavement)

   Layers in the construction of a mortarless pavement: A.) Subgrade B.) Subbase C.) Base course D.) Paver base E.) Pavers F.) Fine-grained sand. In highway engineering, subbase is the layer of aggregate material laid on the subgrade, on which the base course layer is located. It may be omitted when there will be only foot traffic on the pavement ...

5. Construction aggregate - Wikipedia

   en.wikipedia.org/wiki/Construction_aggregate

   In Europe, sizing ranges are specified as d/D, where the d shows the smallest and D shows the largest square mesh grating that the particles can pass. Application-specific preferred sizings are covered in European Standard EN 13043 for road construction, EN 13383 for larger armour stone, EN 12620 for concrete aggregate, EN 13242 for base layers of road construction, and EN 13450 for railway ...

6. Road surface - Wikipedia

   en.wikipedia.org/wiki/Road_surface

   Concrete roadway in San Jose, California A concrete road in Ewing, New Jersey. Concrete surfaces (specifically, Portland cement concrete) are created using a concrete mix of Portland cement, coarse aggregate, sand, and water. In virtually all modern mixes there will also be various admixtures added to increase workability, reduce the required ...

7. Pavers (flooring) - Wikipedia

   en.wikipedia.org/wiki/Pavers_(flooring)

   The base layer should be 6" deep for walkways, or 12" deep for driveways. [10] The base material should either be 3/4" crushed stone (to allow water to drain through it) for a 1/4" crushed stone bedding, or 3/4" minus crushed stone (to prevent sand from sinking through it) for a concrete sand bedding. The base should be compacted every 6".

8. Rubble trench foundation - Wikipedia

   en.wikipedia.org/wiki/Rubble_trench_foundation

   A steel-reinforced concrete grade beam may be poured at the surface to provide ground clearance for the structure. If an insulated slab is to be poured inside the grade beam, then the outer surface of the grade beam and the rubble trench should be insulated with rigid XPS foam board, which must be protected above grade from mechanical and UV ...

9. Foundation (engineering) - Wikipedia

   en.wikipedia.org/wiki/Foundation_(engineering)

   Shallow foundations of a house versus the deep foundations of a skyscraper. Foundation with pipe fixtures coming through the sleeves. In engineering, a foundation is the element of a structure which connects it to the ground or more rarely, water (as with floating structures), transferring loads from the structure to the ground.