Search results
Results from the WOW.Com Content Network
A new reactor is assembled with its control rods fully inserted. Control rods are partially removed from the core to allow the nuclear chain reaction to start up and increase to the desired power level. Neutron flux can be measured, and is roughly proportional to reaction rate and power level. To increase power output, some control rods are ...
An LPCI is an emergency system which consists of a pump that injects a coolant into the reactor vessel once it has been depressurized. In some nuclear power plants an LPCI is a mode of operation of a residual heat removal system, also known as an RHR or RHS but is generally called LPCI. It is also not a stand-alone valve or system.
A nuclear reactor is a device used to initiate and control a fission nuclear chain reaction. They are used for commercial electricity, marine propulsion, weapons production and research. Fissile nuclei (primarily uranium-235 or or plutonium-239) absorb single neutrons and split, releasing energy and multiple neutrons, which can induce further ...
The world's first and only nuclear power plant that put Gen IV reactors into commercial use is Shidao Bay Nuclear Power Plant. The reactor is a high-temperature gas-cooled reactor, started its building process on September 21 2014, [75] started to generate power December 20, 2021, [76] and was put into commercial operation in December 12, 2023 ...
According to the patent application [5] the reactor design has some notable characteristics, that sets it apart from other reactor designs. It uses uranium hydride (UH 3) "low-enriched" to 5% uranium-235—the remainder is uranium-238—as the nuclear fuel, rather than the usual metallic uranium or uranium dioxide that composes the fuel rods of contemporary light-water reactors.
The coolant (treated water), which is maintained at high pressure to prevent boiling, is pumped through the nuclear reactor core. Heat transfer takes place between the reactor core and the circulating water and the coolant is then pumped through the primary tube side of the steam generator by coolant pumps before returning to the reactor core.
The Fukushima Daiichi nuclear disaster in 2011 occurred due to a loss-of-coolant accident. The circuits that provided electrical power to the coolant pumps failed causing a loss-of-core-cooling that was critical for the removal of residual decay heat which is produced even after active reactors are shut down and nuclear fission has ceased.
A diagram of the NuScale Power Module reactor (50 MWe). The NuScale Power Module is the first SMR approved for commercial use in the United States. In 2023, plans to build the first NuScale VOYGR plant in Idaho, known as the Carbon Free Power Project, were scrapped due to excessive increases in power generation costs. [79]