Search results
Results from the WOW.Com Content Network
An addressing mode specifies how to calculate the effective memory address of an operand by using information held in registers and/or constants contained within a machine instruction or elsewhere. In computer programming, addressing modes are primarily of interest to those who write in assembly languages and to compiler writers.
Modbus or MODBUS is a client/server data communications protocol in the application layer. [1] It was originally designed for use with programmable logic controllers (PLCs), [2] but has become a de facto standard communication protocol for communication between industrial electronic devices in a wide range of buses and networks.
In the early days of telephony, with operator handling calls, the addressing formation is by voice as "Operator, connect me to Mr. Smith please". In the first half of the 20th century, addressing formation is done by using a rotary dial , which rapidly breaks the line current into pulses , with the number of pulses conveying the address.
Another commonly used notation represents the mode as a (CPOL, CPHA) tuple; e.g., the value '(0, 1)' would indicate CPOL=0 and CPHA=1. In Full Duplex operation, the master device could transmit and receive with different modes. For instance, it could transmit in Mode 0 and be receiving in Mode 1 at the same time.
The address modifier is a 6 bit wide set of signals on the backplane. Address modifiers specify the number of significant address bits, the privilege mode (to allow processors to distinguish between bus accesses by user-level or system-level software), and whether or not the transfer is a block transfer.
2.2 The selected node takes the address from the LIN configuration message 2.3 The detected node turns on the pull-down at the output D 2 2.4 Steps 2.1-2.4 are repeated until all slave nodes are assigned an address. 3 All pull-ups and pull-downs are turned off completing the addressing procedure
High-Level Data Link Control (HDLC) is a communication protocol used for transmitting data between devices in telecommunication and networking.Developed by the International Organization for Standardization (ISO), it is defined in the standard ISO/IEC 13239:2002.
Mode Command With Data Word (Transmit). The Bus Controller sends one command word with a Sub-address of 0 or 31 signifying a Mode Code type command. The Remote Terminal responds with a Status word immediately followed by a single Data word. Mode Command With Data Word (Receive). The Bus Controller sends one command word with a Sub-address of 0 ...