enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   A plow bolt is bolt similar to a carriage bolt, except the head is flat or concave, and the underside of the head is a cone designed to fit in a countersunk recess. Plow bolts provide a smooth surface for attaching a plow moldboard to its beam, where a raised head would suffer from soil abrasion. There are many variations, with some not using a ...

3. Concrete pavement restoration - Wikipedia

   en.wikipedia.org/wiki/Concrete_Pavement_Restoration

   CPP and CPR techniques include slab stabilization, full- and partial-depth repair, dowel bar retrofit, cross stitching longitudinal cracks or joints, diamond grinding and joint and crack resealing. CPP and CPR methods, developed over the last 40 years, are used in lieu of asphalt overlays and bituminous patches to repair roads when longer ...

4. Countersink - Wikipedia

   en.wikipedia.org/wiki/Countersink

   Side and end view of a 4-fluted countersink. The fluted countersink cutter is used to provide a heavy chamfer in the entrance to a drilled hole. This may be required to allow the correct seating for a countersunk-head screw or to provide the lead in for a second machining operation such as tapping.

5. Concrete cone failure - Wikipedia

   en.wikipedia.org/wiki/Concrete_cone_failure

   The tension failure loads predicted by the CCD method fits experimental results over a wide range of embedment depth (e.g. 100 – 600 mm). [2] Anchor load bearing capacity provided by ACI 349 does not consider size effect, thus an underestimated value for the load-carrying capacity is obtained for large embedment depths.

6. Anchor bolt - Wikipedia

   en.wikipedia.org/wiki/Anchor_bolt

   The last are used in concrete-steel composite structures as shear connectors. [6] Other uses include anchoring machines to poured concrete floors [7] and buildings to their concrete foundations. Various typically disposable aids, mainly of plastic, are produced to secure and align cast-in-place anchors prior to concrete placement.

7. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than ⁠ 1 / 4 ⁠ inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.

8. Counterbore - Wikipedia

   en.wikipedia.org/wiki/Counterbore

   Comparison of countersunk and counterbored holes. Counterbore cutter marked 'E A counterbore hole is usually used when the head of a fastener, such as a hex head or socket head capscrew, is required to be flush with or below the level of a workpiece's surface.

9. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   A lathe of 1871, equipped with leadscrew and change gears for single-point screw-cutting A Brown & Sharpe single-spindle screw machine. Fasteners had become widespread involving concepts such as dowels and pins, wedging, mortises and tenons, dovetails, nailing (with or without clenching the nail ends), forge welding, and many kinds of binding with cord made of leather or fiber, using many ...