Search results
Results from the WOW.Com Content Network
At Coventry cathedral, Araldite adhesive was used to bond its columns and fins, while at Sydney Opera House, Araldite adhesive was used to bond the rib sections of the shells, since a traditional concrete joint would have slowed construction, as it would need 24 hours to cure before stressing. [5]
On the other hand, for completely dry concrete, the chemical reaction of carbonation cannot occur. Another influencing factor for CO 2 diffusion rate is concrete porosity. Concrete obtained with higher w/c ratio or obtained with an incorrect curing process presents higher porosity at hardened state, and is therefore subjected to a higher ...
Preconsolidation pressure is the maximum effective vertical overburden stress that a particular soil sample has sustained in the past. [1] This quantity is important in geotechnical engineering, particularly for finding the expected settlement of foundations and embankments.
Concrete has a very low coefficient of thermal expansion, and as it matures concrete shrinks. All concrete structures will crack to some extent, due to shrinkage and tension. Concrete which is subjected to long-duration forces is prone to creep. The density of concrete varies, but is around 2,400 kilograms per cubic metre (150 lb/cu ft). [1]
Soil compaction is a vital part of the construction process. It is used for support of structural entities such as building foundations, roadways, walkways, and earth retaining structures to name a few. For a given soil type certain properties may deem it more or less desirable to perform adequately for a particular circumstance.
The sorptivity is widely used in characterizing soils and porous construction materials such as brick, stone and concrete. Calculation of the true sorptivity required numerical iterative procedures dependent on soil water content and diffusivity.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The plate assemblies are fabricated off site, and welded together on-site to form steel walls connected by stringers. The walls become the form into which concrete is poured. Steel plate construction speeds reinforced concrete construction by cutting out the time-consuming on-site manual steps of tying rebar and building forms.