Search results
Results from the WOW.Com Content Network
A data collection charge is a fee paid to the data collector for determining the energy consumption of the supply. The charge may be shown separately on an electricity bill or it may be incorporated in the electricity supplier's overall charges.
The cost of electricity also differs by the power source. The net present value of the unit-cost of electricity over the lifetime of a generating asset is known as the levelized cost of electricity (LCOE). However, LCOE does not account for the system costs, in particular related to the guarantee of grid stability and power quality, which can ...
MSP kWh is the amount of electricity consumed at the 'meter supply point', which is the customer's meter. GSP kWh is obtained by multiplying the MSP kWh by the Line Loss Factor (LLF, a figure > 1) to include the amount of electricity lost when it is conducted through the distribution network, from the 'grid supply point' to the customer's meter.
The levelized cost of electricity (LCOE) is a metric that attempts to compare the costs of different methods of electricity generation consistently. Though LCOE is often presented as the minimum constant price at which electricity must be sold to break even over the lifetime of the project, such a cost analysis requires assumptions about the value of various non-financial costs (environmental ...
Moisture dew point is the temperature at which moisture condenses out of a gas. This parameter is inherently related to the moisture content, which defines the amount of water molecules as a fraction of the total. Both can be used as a measure of the amount of moisture in a gas and one can be calculated from the other fairly accurately.
Net metering enables small systems to result in zero annual net cost to the consumer provided that the consumer is able to shift demand loads to a lower price time, such as by chilling water at a low cost time for later use in air conditioning, or by charging a battery electric vehicle during off-peak times, while the electricity generated at ...
The density of thermal energy contained in the core of a light-water reactor (pressurized water reactor (PWR) or boiling water reactor (BWR)) of typically 1 GW (1000 MW electrical corresponding to ≈ 3000 MW thermal) is in the range of 10 to 100 MW of thermal energy per cubic meter of cooling water depending on the location considered in the ...
Since electrical energy is a form of energy that cannot be effectively stored in bulk, it must be generated, distributed, and consumed immediately. When the load on a system approaches the maximum generating capacity, network operators must either find additional supplies of energy or find ways to curtail the load, hence load management.