Search results
Results from the WOW.Com Content Network
Drill bit sizes are written as irreducible fractions. So, instead of 78/64 inch, or 1 14/64 inch, the size is noted as 1 7/32 inch. Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths).
Last, multiply the original expression of the physical value by the fraction, called a conversion factor, to obtain the same physical value expressed in terms of a different unit. Note: since valid conversion factors are dimensionless and have a numerical value of one , multiplying any physical quantity by such a conversion factor (which is 1 ...
Thus, the outer diameter of a catheter in millimeters can be calculated by dividing the French size by 3. [2] For example, a catheter with a French size of 9 would have an outer diameter of approximately 3.07 mm. While the French scale aligns closely with the metric system, it introduces redundancy and the potential for rounding errors.
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
Metric units are units based on the metre, gram or second and decimal (power of ten) multiples or sub-multiples of these. According to Schadow and McDonald, [ 1 ] metric units, in general, are those units "defined 'in the spirit' of the metric system, that emerged in late 18th century France and was rapidly adopted by scientists and engineers.
35 mm was in use in the 1930s and 1940s by several model railway manufacturers in Japan. 35 mm was introduced in the 1930s. Late 1940s 35 mm was replaced by O gauge. No. 2: 1:27: 2 in (50.8 mm) English scale, 7 ⁄ 16 inch to 1 foot. Commercially used about 1900 [citation needed]
The last is typically longer than the foot heel to toe length by 4 ⁄ 3 cm (13.33 mm) to 5 ⁄ 3 cm (16.67 mm), or 2 to 2 + 1 ⁄ 2 Paris points, so to determine the shoe size based on actual foot length one must add 2 Paris points. Because a Paris point is 2 ⁄ 3 of a centimetre, a centimetre is 3 ⁄ 2 Paris points, and the formula is as ...