Search results
Results from the WOW.Com Content Network
Fault detection, isolation, and recovery (FDIR) is a subfield of control engineering which concerns itself with monitoring a system, identifying when a fault has occurred, and pinpointing the type of fault and its location. Two approaches can be distinguished: A direct pattern recognition of sensor readings that indicate a fault and an analysis ...
This is usually handled with a separate "automated fault-detection system". In the case of the tire, an air pressure monitor detects the loss of pressure and notifies the driver. The alternative is a "manual fault-detection system", such as manually inspecting all tires at each stop. Interference with fault detection in another component.
X-ray reflectometry: is a surface-sensitive analytical technique used in chemistry, physics, and materials science to characterize surfaces, thin films and multilayers. Propagation of electric pulses and reflection at discontinuities in cables is used in time domain reflectometry (TDR) to detect and localize defects in electric wiring. [2] [3]
Inflight maintenance checklist procedure before starting waste collection system repair on board the Atlantis shuttle. Corrective maintenance is a maintenance task performed to identify, isolate, and rectify a fault so that the failed equipment, machine, or system can be restored to an operational condition within the tolerances or limits established for in-service operations.
Fault detection coverage that system built-in test will realize; Whether the analysis will be functional or piece-part; Criteria to be considered (mission abort, safety, maintenance, etc.) System for uniquely identifying parts or functions; Severity category definitions
Soft errors in logic circuits are sometimes detected and corrected using the techniques of fault tolerant design. These often include the use of redundant circuitry or computation of data, and typically come at the cost of circuit area, decreased performance, and/or higher power consumption.
The conventionally used aid in cable fault testing and location is the cable test van. The van is installed with conventional cable measuring systems for quickly reaching the location of any cable fault. In 20 years that followed, over 2000 fault location vehicles were manufactured, more than half of which were intended for the former USSR.
A fault model, falls under one of the following assumptions: single fault assumption: only one fault occur in a circuit. if we define k possible fault types in our fault model the circuit has n signal lines, by single fault assumption, the total number of single faults is k×n. multiple fault assumption: multiple faults may occur in a circuit.