Search results
Results from the WOW.Com Content Network
Abrasion strips on helicopter rotor blades are made of metal, often titanium or nickel, which are very hard, but less hard than sand. When a helicopter flies low to the ground in desert environments, sand striking the rotor blade can cause erosion. At night, sand hitting the metal abrasion strip causes a visible corona or halo around the rotor ...
The collective changes the pitch angle of all the main rotor blades collectively (i.e., all at the same time) and is independent of their position in the rotational cycle. Therefore, if a collective input is made, all the blades change equally, and as a result, the helicopter increases or decreases its total lift derived from the rotor.
The drive shafts of helicopter engines are typically not aligned with the rotor shafts, so the transmission must translate the alignment of the drive shaft to match the shafts of the rotors. Many engine drive shafts are aligned horizontally, yet the main rotor shaft ("mast") is usually vertical, and the tail rotor shaft is often perpendicular ...
The rotorhead is where the lift force from the rotor blades act. The rotorhead is connected to the main drive shaft via the Jesus nut, and houses several other components such as the swash plate, flight control linkages and fly-bars. [1] The rotor hub is also where the centre of gravity acts on the helicopter. The rotor head of a Sikorsky S-92
In aeronautics, a swashplate is a mechanical device that translates input via the helicopter flight controls into motion of the main rotor blades. Because the main rotor blades are spinning, the swashplate is used to transmit three of the pilot's commands from the non-rotating fuselage to the rotating rotor hub and mainblades.
The pitch of the tail rotor blades is adjustable by the pilot via the anti-torque pedals, which also provide directional control by allowing the pilot to rotate the helicopter around its vertical axis. Its drive system consists of a shaft powered from the main transmission and a gearbox mounted at the end of the tail boom.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
A helicopter is susceptible to a rolling tendency, called dynamic rollover, when close to the ground, especially when taking off or landing. For dynamic rollover to occur, some factor has to first cause the helicopter to roll or pivot around a skid, or landing gear wheel, until its critical rollover angle is reached.