enow.com Web Search

  1. Ads

    related to: steering wheel spline sizes

Search results

  1. Results from the WOW.Com Content Network
  2. Spline (mechanical) - Wikipedia

    en.wikipedia.org/wiki/Spline_(mechanical)

    A spline is a ridge or tooth [1] [2] [3] on a drive shaft that matches with a groove in a mating piece and transfers torque to it, maintaining the angular correspondence between them. For instance, a gear mounted on a shaft might use a male spline on the shaft that matches the female spline on the gear.

  3. List of gear nomenclature - Wikipedia

    en.wikipedia.org/wiki/List_of_gear_nomenclature

    It is used as a measure of the effective size of a gear. The test radius of the master, plus the test radius of the work gear is the set up center distance on a composite action test device. Test radius is not the same as the operating pitch radii of two tightly meshing gears unless both are perfect and to basic or standard tooth thickness.

  4. Steering wheel - Wikipedia

    en.wikipedia.org/wiki/Steering_wheel

    A steering wheel (also called a driving wheel, a hand wheel, or simply wheel) is a type of steering control in vehicles. Steering wheels are used in most modern land vehicles, including all mass-production automobiles , buses, light and heavy trucks, as well as tractors and tanks .

  5. Dana 60 - Wikipedia

    en.wikipedia.org/wiki/Dana_60

    1.41” Front (32 spline) 1.46” Rear (32 spline) 1.50” Front (35 spline) 1.50” Rear (35 spline) Inner axle shaft splines: 16, 23, 30, 32, 33 or 35 Aftermarket inner axle shaft splines: 40 for after market, high performance axles, equivalent to Dana 70 components; Pinion shaft diameter: 1.625" Pinion shaft splines: 10 or 29

  6. Parallelogram steering linkage - Wikipedia

    en.wikipedia.org/wiki/Parallelogram_steering_linkage

    A parallelogram steering linkage is called such because like its namesake, the two sides of the linkage run parallel to each other and are equal in distance. This type of steering linkage uses four tie rods, one inner and one outer on each side (left and right) that are connected by an adjustment sleeve, a center link (which runs between the tie rods), an idler arm on the passenger side, and a ...

  7. Ackermann steering geometry - Wikipedia

    en.wikipedia.org/wiki/Ackermann_steering_geometry

    The steering pivot points [clarification needed] are joined by a rigid bar called the tie rod, which can also be part of the steering mechanism, in the form of a rack and pinion for instance. With perfect Ackermann, at any angle of steering, the centre point of all of the circles traced by all wheels will lie at a common point.

  1. Ads

    related to: steering wheel spline sizes