enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Resin casting - Wikipedia

   en.wikipedia.org/wiki/Resin_casting

   A custom resin cast Pinky:St part and two-part silicone mold. Resin casting is used to produce collectible and customized toys and figures like designer toys, garage kits and ball-jointed dolls, as well as scale models, either individual parts or entire models of objects like trains, aircraft or ships. They are generally produced in small ...

3. Spin casting - Wikipedia

   en.wikipedia.org/wiki/Spin_casting

   The spin casting process typically uses vulcanized silicone or organic rubber as the mold-making substrate. Vulcanization is an integral step that occurs halfway through the mold-making process. Prior to vulcanization, the mold rubber is a soft and malleable solid-like fluid, in many ways very similar to Silly Putty. Because of the clay-like ...

4. Silicone - Wikipedia

   en.wikipedia.org/wiki/Silicone

   Two-part silicone systems are used as rubber molds to cast resins, foams, rubber, and low-temperature alloys. A silicone mold generally requires little or no mold-release or surface preparation, as most materials do not adhere to silicone. For experimental uses, ordinary one-part silicone can be used to make molds or to mold into shapes.

5. Silicone rubber - Wikipedia

   en.wikipedia.org/wiki/Silicone_rubber

   In its uncured state, silicone rubber is a highly adhesive gel or liquid. To convert it to a solid, it must be cured, vulcanized, or catalyzed.This is normally carried out in a two-stage process at the point of manufacture into the desired shape, and then in a prolonged post-cure process.

6. Compression molding - Wikipedia

   en.wikipedia.org/wiki/Compression_molding

   Compression molding is a method of molding in which the molding material, generally preheated, is first placed in an open, heated mold cavity. The mold is closed with a top force or plug member, pressure is applied to force the material into contact with all mold areas, while heat and pressure are maintained until the molding material has cured; this process is known as compression molding ...

7. How to Make a Jell-O Mold That Comes Out Perfect

   www.aol.com/jell-o-mold-comes-perfect-150003594.html

   Use hot water to remove a stubborn Jell-O mold: If your mold isn’t releasing from the pan, set the mold in a pan of hot water for 10 seconds and try to remove it again. Repeat the process until ...