Search results
Results from the WOW.Com Content Network
Below is the full 8086/8088 instruction set of Intel (81 instructions total). [2] These instructions are also available in 32-bit mode, in which they operate on 32-bit registers (eax, ebx, etc.) and values instead of their 16-bit (ax, bx, etc.) counterparts.
The 8086 [3] (also called iAPX 86) [4] is a 16-bit microprocessor chip designed by Intel between early 1976 and June 8, 1978, when it was released. The Intel 8088, released July 1, 1979, [5] is a slightly modified chip with an external 8-bit data bus (allowing the use of cheaper and fewer supporting ICs), [note 1] and is notable as the processor used in the original IBM PC design.
The VIA/Zhaoxin PadLock instructions are instructions designed to apply cryptographic primitives in bulk, similar to the 8086 repeated string instructions. As such, unless otherwise specified, they take, as applicable, pointers to source data in ES:rSI and destination data in ES:rDI, and a data-size or count in rCX.
In computer architecture, a control bus is part of the system bus and is used by CPUs for communicating with other devices within the computer. While the address bus carries the information about the device with which the CPU is communicating and the data bus carries the actual data being processed, the control bus carries commands from the CPU and returns status signals from the devices.
Apart from the machine instructions which allow one to set/get the position of the GDT, and of the Interrupt Descriptor Table (IDT), in memory, every machine instruction referencing memory has an implicit segment register, occasionally two. Most of the time this segment register can be overridden by adding a segment prefix before the instruction.
Control transfer instructions (jump and call) allow a 20-bit address to be specified, while indirect control transfers use the concatenation of a 16-bit register address and a 4-bit "code segment" register. Unlike the 8086 microprocessor, there are no separate near and far return instructions; all subroutine calls push the full 20-bit return ...
System Call is used by user mode software to make kernel calls; and Breakpoint is used to transfer control to a debugger via the kernel's exception handler. Both instructions have a 20-bit Code field that can contain operating environment-specific information for the exception handler. MIPS has 32 floating-point registers.
Instructions to load both extended segment register and general-purpose register at once, similar to 8086's LDS and LES instructions MOV DS2,r16,m32: 0F 3E /r: DS2: 63: Segment-override prefixes for the DS2 and DS3 extended segments. DS3: D6: IRAM: F1: Register File Override Prefix. Will cause memory operands to index into register file rather ...