Search results
Results from the WOW.Com Content Network
Four PCI Express bus card slots (from top to second from bottom: ×4, ×16, ×1 and ×16), compared to a 32-bit conventional PCI bus card slot (very bottom). In computer architecture, a bus (historically also called a data highway [1] or databus) is a communication system that transfers data between components inside a computer or between computers. [2]
The physical phenomena on which the device relies (such as spinning platters in a hard drive) will also impose limits; for instance, no spinning platter shipping in 2009 saturates SATA revision 2.0 (3 Gbit/s), so moving from this 3 Gbit/s interface to USB 3.0 at 4.8 Gbit/s for one spinning drive will result in no increase in realized transfer rate.
A system bus is a single computer bus that connects the major components of a computer system, combining the functions of a data bus to carry information, an address bus to determine where it should be sent or read from, and a control bus to determine its operation. The technique was developed to reduce costs and improve modularity, and ...
4-bit computing is the use of computer architectures in which integers and other data units are 4 bits wide. 4-bit central processing unit (CPU) and arithmetic logic unit (ALU) architectures are those that are based on registers or data buses of that size. A group of four bits is also called a nibble and has 2 4 = 16 possible values, with a ...
3GPP2—3rd Generation Partnership Project 2; 3NF—third normal form; 386—Intel 80386 processor; 486—Intel 80486 processor; 4B5BLF—4-bit 5-bit local fiber; 4GL—fourth-generation programming language; 4NF—fourth normal form; 5GL—fifth-generation programming language; 5NF—fifth normal form; 6NF—sixth normal form; 8B10BLF—8-bit ...
In computer architecture, a control bus is part of the system bus and is used by CPUs for communicating with other devices within the computer. While the address bus carries the information about the device with which the CPU is communicating and the data bus carries the actual data being processed, the control bus carries commands from the CPU and returns status signals from the devices.
SMBus 2.0 defines a ‘High Power’ class that includes a 4 mA sink current that cannot be driven by I²C chips unless the pull-up resistor is sized to I²C-bus levels. NXP devices have a higher power set of electrical characteristics than SMBus 1.0. The main difference is the current sink capability with V OL = 0.4 V. SMBus low power = 350 μA
The DMI bus is visible between CPU and PCH. DMI is essentially PCI Express, using multiple lanes and differential signaling to form a point-to-point link. Most implementations use a ×8 or ×4 link, while some mobile systems (e.g. 915GMS, 945GMS/GSE/GU and the Atom N450) use a ×2 link, halving the bandwidth. The original implementation ...