enow.com Web Search

  1. Ads

    related to: paddle wheel flow rate meter f 1000 rb 1

Search results

  1. Results from the WOW.Com Content Network
  2. Flow measurement - Wikipedia

    en.wikipedia.org/wiki/Flow_measurement

    Similarly to turbine meters, the paddle wheel meter requires a minimum run of straight pipe before and after the sensor. Flow displays and controllers are used to receive the signal from the paddle wheel meter and convert it into actual flow rate or total flow values.

  3. Level sensor - Wikipedia

    en.wikipedia.org/wiki/Level_sensor

    Rotating paddle level sensors are a very old and established technique for bulk solid point level indication. The technique uses a low-speed gear motor that rotates a paddle wheel. When the paddle is stalled by solid materials, the motor is rotated on its shaft by its own torque until a flange mounted on the motor contacts a mechanical switch.

  4. Paddle wheel - Wikipedia

    en.wikipedia.org/wiki/Paddle_wheel

    A paddle wheel aereator used in an Indonesian shrimp pond. A paddle wheel is a form of waterwheel or impeller in which a number of paddles are set around the periphery of the wheel. It has several uses, of which some are: Very low-lift water pumping, such as flooding paddy fields at no more than about 0.5 m (20 in) height above the water source ...

  5. Dethridge wheel - Wikipedia

    en.wikipedia.org/wiki/Dethridge_wheel

    Dethridge wheel in 1936 – Victoria Australia. The Dethridge wheel is an irrigation tool that was invented in 1910 by John Stewart Dethridge (1865–1926). [1] It works in a similar way to a traditional water wheel and rotates as water passes through its vanes. The rotations are then measured [2]

  6. Pelton wheel - Wikipedia

    en.wikipedia.org/wiki/Pelton_wheel

    By Newton's second and third laws, the force F imposed by the jet on the runner is equal but opposite to the rate of momentum change of the fluid, so F = −m(V f − V i)/t = −ρQ[(−V i + 2u) − V i] = −ρQ(−2V i + 2u) = 2ρQ(V i − u), where ρ is the density, and Q is the volume rate of flow of fluid.

  7. Flow show - Wikipedia

    en.wikipedia.org/wiki/Flow_show

    The angle of the paddle increases as the volume of drilling fluid increases and pushes it out further and vice versa. The purpose of the flow show is to allow the driller (and other rig personnel) to monitor the flow of drilling fluid as it comes out of the hole. [1] The reasons for monitoring the flow [citation needed]:

  1. Ads

    related to: paddle wheel flow rate meter f 1000 rb 1