Search results
Results from the WOW.Com Content Network
Under the Harappan linear measures, Indus cities during the Bronze Age used a foot of 13.2 inches (335 mm) and a cubit of 20.8 inches (528 mm). [11] The Egyptian equivalent of the foot—a measure of four palms or 16 digits—was known as the djeser and has been reconstructed as about 30 cm (11.8 in).
Decimal numbers are not divided directly, the dividend and divisor are multiplied by a power of ten so that the division involves two whole numbers. Therefore, if one were dividing 12,7 by 0,4 (commas being used instead of decimal points), the dividend and divisor would first be changed to 127 and 4, and then the division would proceed as above.
Its volume would be multiplied by the cube of 2 and become 8 m 3. The original cube (1 m sides) has a surface area to volume ratio of 6:1. The larger (2 m sides) cube has a surface area to volume ratio of (24/8) 3:1. As the dimensions increase, the volume will continue to grow faster than the surface area. Thus the square–cube law.
The US survey foot is defined so that 1 metre is exactly 39.37 inches, making the international foot of 0.3048 metres exactly two parts per million shorter. This is a difference of just over 3.2 mm, or a little more than one-eighth of an inch per mile.
In terms of partition, 20 / 5 means the size of each of 5 parts into which a set of size 20 is divided. For example, 20 apples divide into five groups of four apples, meaning that "twenty divided by five is equal to four". This is denoted as 20 / 5 = 4, or 20 / 5 = 4. [2] In the example, 20 is the dividend, 5 is the divisor, and 4 is ...
There are anecdotal objections to the use of metric units in carpentry and the building trades, on the basis that it is easier to remember an integer number of inches plus a fraction, rather than a measurement in millimeters, [9] or that foot-inch measurements are more suitable when distances are frequently divided into halves, thirds, and ...
Make web pages easy to read for you! With simple keyboard shortcuts, you can zoom in or out to make text larger or smaller. In an instant, these commands improve the readability of the content you're viewing. • Zoom in - Press Ctrl (CMD on a Mac) + the plus key (+) on your keyboard.
Let x = the repeating decimal: x = 0.1523 987; Multiply both sides by the power of 10 just great enough (in this case 10 4) to move the decimal point just before the repeating part of the decimal number: 10,000x = 1,523. 987; Multiply both sides by the power of 10 (in this case 10 3) that is the same as the number of places that repeat: