Search results
Results from the WOW.Com Content Network
To compensate for the uneven (35/65) weight distribution caused by the rear-mounted engine, DeLorean used rear wheels with a diameter slightly greater than the front wheels. Before that was the rear-engined Škoda's from Škoda 1000MB (produced from 1964) to Škoda 130/135/136 (produced until 1990) or the Polski Fiat 126p (produced until ...
Diagram of a typical gas turbine jet engine. Air is compressed by the compressor blades as it enters the engine, and it is mixed and burned with fuel in the combustion section. The hot exhaust gases provide forward thrust and turn the turbines which drive the compressor blades.
The TH400 was phased out for the 1980 models, when the A-727 replaced the TH-400 as the only automatic transmission option for both the SJ Wagoneer/Cherokee wagons and the J-10/J-20 trucks. Internally similar to the Chrysler A-727, the case was one-piece, cast with an AMC pattern bellhousing (not interchangeable with a Chrysler pattern A-727).
Rear-wheel drive (RWD) is a form of engine and transmission layout used in motor vehicles, in which the engine drives the rear wheels only. Until the late 20th century, rear-wheel drive was the most common configuration for cars. Most rear-wheel drive vehicles feature a longitudinally-mounted engine at the front of the car.
A PTO at the rear end of a farm tractor A PTO (in the box at the bottom) in the center of the three-point hitch of a tractor. A power take-off or power takeoff (PTO) is one of several methods for taking power from a power source, such as a running engine, and transmitting it to an application such as an attached implement or separate machine.
In automobile design, a rear-engine design layout places the engine at the rear of the vehicle. The center of gravity of the engine itself is behind the rear axle. This is not to be confused with the center of gravity of the whole vehicle, as an imbalance of such proportions would make it impossible to keep the front wheels on the ground.
The starter motor may mount to it, and it may support clutch and/or shifter linkage. [2] A Bellhousing may be a separate housing bolted to the gearbox, or it may be an integral portion of the transmission housing, particularly with front wheel drive transmissions. An integral bell has a front bolt pattern that matches the engine to which it ...
One-way bearing combining sprags and bearing rollers in one race Sprags jam when driven and slide when in reverse. A sprag clutch is a one-way freewheel clutch.It resembles a roller bearing but, instead of cylindrical rollers, non-revolving asymmetric figure-eight shaped sprags, or other elements allowing single direction rotation, are used.