Search results
Results from the WOW.Com Content Network
Schuko sockets can accept two-pin unearthed Europlug (CEE 7/16) and CEE 7/17. Less safely, Schuko plugs can be inserted into many two-pin unearthed CEE 7/1 sockets and into some sockets with a different form of earth connection that will not mate with the earth contacts on the Schuko plug (e.g., some variants of the Danish socket).
In electricity supply design, a ring circuit is an electrical wiring technique in which sockets and the distribution point are connected in a ring. It is contrasted with the usual radial circuit, in which sockets and the distribution point are connected in a line with the distribution point at one end.
A jumbo four-prong socket was used for various industrial tubes. A specialized seven-pin socket (Septar or B7A), with all pins in a circle with one pin wider than the others, was used for transmitting tubes. Subminiature tubes with long wire leads, introduced in the 1950s, were often soldered directly to printed circuit boards.
Note the connection of the security system to the phone line requires a wiring configuration that allows the security system to disconnect all phones in the home when it needs to connect to the monitoring center. This is critical, if the wiring is not correct the system may not communicate back to base when an intrusion is detected.
It is possible to use Socket 7 processors in a Socket 5. An adapter is required, or if one is careful, a socket 7 can be pulled off its pins and put onto a socket 5 board, allowing the use of socket 7 processors. Socket 8: 1995 Intel Pentium Pro: PGA: 387 ? 60–66 MHz Slot 1: 1997 Intel Pentium II Intel Pentium III: Desktop Slot: 242 ? 66 ...
Mechanical wire wrap tool Electrical wire wrap tool; pneumatic (air-powered) tools are also available. A "wire wrap tool" has two holes. The wire and 1 ⁄ 4 in (6.4 mm) of insulated wire are placed in a hole near the edge of the tool. The hole in the center of the tool is placed over the post.
Log in to your AOL account to access email, news, weather, and more.
When a generic power outlet was desired, the wiring could run directly into the junction box through a tube of protective loom and a ceramic bushing. Wiring devices such as light switches, receptacle outlets, and lamp sockets were either surface-mounted, suspended, or flush-mounted within walls and ceilings.