Search results
Results from the WOW.Com Content Network
A range of rugged hand-held scan tools is available. Simple fault code readers/reset tools are mostly aimed at the consumer level. Professional hand-held scan tools may possess more advanced functions Access more advanced diagnostics; Set manufacturer- or vehicle-specific ECU parameters; Access and control other control units, such as air bag ...
OBD 1 vs OBD 2 the vehicle will also dictate what the scan tool is able to display. If the vehicle is equipped with OBD 1 it will have significantly less available data when compared to a vehicle equipped with OBD 2. [2] When a vehicle detects a problem, it generates a DTC code which is a unique code that corresponds to the specific problem ...
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections .
A controller area network (CAN) is a vehicle bus standard designed to enable efficient communication primarily between electronic control units (ECUs). Originally developed to reduce the complexity and cost of electrical wiring in automobiles through multiplexing, the CAN bus protocol has since been adopted in various other contexts.
The data link connector (DLC) is the multi-pin diagnostic connection port for automobiles, trucks, and motorcycles used to interface a scan tool with the control modules of a given vehicle and access on-board diagnostics and live data streams. [1] Prior to 1996, many OBD-I data link connector's were in the engine compartment, usually near the ...
The ELM327 is a programmed microcontroller produced for translating the on-board diagnostics (OBD) interface found in most modern cars. The ELM327 command protocol is one of the most popular PC-to-OBD interface standards and is also implemented by other vendors.
Unified Diagnostic Services (UDS) is a diagnostic communication protocol used in electronic control units (ECUs) within automotive electronics, which is specified in the ISO 14229-1. [1] It is derived from ISO 14230-3 ( KWP2000 ) and the now obsolete ISO 15765 -3 (Diagnostic Communication over Controller Area Network (DoCAN) [ 2 ] ).
In addition, there is an optional L-line for wakeup. The data rate is between 1.2 and 10.4 kilobaud, and a message may contain up to 255 bytes in the data field. [1] When implemented on a K-line physical layer KWP2000 requires special wakeup sequences: 5-baud wakeup and fast-initialisation. Both of these wakeup methods require timing critical ...