Search results
Results from the WOW.Com Content Network
Regenerative and friction braking must both be used, creating the need to control them to produce the required total braking. The GM EV-1 was the first commercial car to do this. In 1997 and 1998, engineers Abraham Farag and Loren Majersik were issued two patents for this brake-by-wire technology. [3] [4]
In 1999, a new Bronco was secretly developed under Moray Callum, as a simple inexpensive off-roader in the spirit of the first generation Bronco, rather than the later full-size models. Planned as a 2-door and 4-door, it was codenamed U260, U meaning utility, 2 meaning 2-door, and 60 referring to the Ford Ranger's T6 platform it would have used ...
The G.O.A.T. modes allow the driver to select different terrains for the 4x4 system. The Bronco Sport has four-wheel independent suspension. Only the Badlands model has a twin-clutch rear differential that can act as a rear differential locker and has torque vectoring. Unlike the Bronco, the Bronco Sport does not have a low-range transfer case ...
These problems have the same cause: a regenerative receiver's gain is greatest when it operates on the verge of oscillation, and in that condition, the circuit behaves chaotically. [ 28 ] [ 29 ] [ 30 ] Simple regenerative receivers electrically couple the antenna to the detector tuned circuit, resulting in the electrical characteristics of the ...
The Bronco has been in service with the Singapore Armed Forces since 2001, with more than 600 delivered. [8] In 2007, Thailand became the first export customer for the Bronco. The Bronco has undergone extensive trials in a number of countries, including Finland, France, Morocco, Turkey and the US. [9]
The regenerative receiver also had its heyday at the time where adding an active element (vacuum tube) was considered costly. In order to increase the gain of the receiver, positive feedback was used in its single RF amplifier stage; this also increased the selectivity of the receiver well beyond what would be expected from a single tuned circuit.
A shortwave radio receiver is a radio receiver that can receive one or more shortwave bands, between 1.6 and 30 MHz. A shortwave radio receiver often receives other broadcast bands, such as FM radio, Longwave and Mediumwave. Shortwave radio receivers are often used by dedicated hobbyists called shortwave listeners.
A 5-tube superheterodyne receiver manufactured by Toshiba circa 1955 Superheterodyne transistor radio circuit circa 1975. A superheterodyne receiver, often shortened to superhet, is a type of radio receiver that uses frequency mixing to convert a received signal to a fixed intermediate frequency (IF) which can be more conveniently processed than the original carrier frequency.