Search results
Results from the WOW.Com Content Network
On steering wheels for cars utilizing bolt circles, this usually measures 6×70 mm. [3] Some racing wheels attach to the car via a quick release hub, [4] and this hub then usually has a corresponding bolt circle of 6×70 mm. Example of other less used patterns include: 3×1.75 in (44.45 mm), 5×2.75 in (69.85 mm), 6×74 mm and 6×2.75 in (69.85 mm).
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25).
The large-journal connecting rods were thicker (heavier) and used 3 ⁄ 8 in (9.5 mm) diameter cap-bolts to replace the small-journal's 11/32. 1968 blocks were made in 2-bolt and 4-bolt versions with the 4-bolt center-three main caps each fastened by two additional bolts which were supported by the addition of thicker crankcase main-web bulkheads.
Sex bolt: Barrel nut, barrel bolt, binding barrel, Chicago screw, post and screw or connector bolt Has a barrel-shaped flange and protruding boss that is internally threaded Split nut: Split lengthwise into two pieces (opposed halves) so that its female thread may be opened and closed over the male thread of a bolt or leadscrew Sleeve nut ...
The ultimate tensile strength of a material is an intensive property; therefore its value does not depend on the size of the test specimen.However, depending on the material, it may be dependent on other factors, such as the preparation of the specimen, the presence or otherwise of surface defects, and the temperature of the test environment and material.
The 322 Fireball V8 in a 1956 Buick Century. Buick's first generation V8 was offered from 1953 through 1956; it replaced the Buick straight-eight.While officially called the "Fireball V8" [1] by Buick, it became known by enthusiasts as the "Nailhead" for the unusual vertical alignment of its small-sized valves (Originally it was known to hot-rodders as the "nail valve", because the engine's ...
It used a new 4.13-inch (104.90 mm) bore with the 390's 3.785-inch (96.14 mm) stroke, giving a displacement of 405.7 cu in (6.6 L), rounded up to "406" for the official designation. The larger bore required a new block casting design allowing for thicker walls, but otherwise was very similar to the 390 block.