Search results
Results from the WOW.Com Content Network
Stresses in a contact area loaded simultaneously with a normal and a tangential force. Stresses were made visible using photoelasticity. Contact mechanics is the study of the deformation of solids that touch each other at one or more points.
But if the normal stress in the contact interface induces the same tangential displacements in both contacting bodies, then there is no relative tangential displacement of the two surfaces. In that case, the normal and tangential contact problems are decoupled. If this is the case then the two bodies are called quasi-identical. This happens for ...
Illustration of tangential and normal components of a vector to a surface. In mathematics, given a vector at a point on a curve, that vector can be decomposed uniquely as a sum of two vectors, one tangent to the curve, called the tangential component of the vector, and another one perpendicular to the curve, called the normal component of the vector.
Traction can also refer to the maximum tractive force between a body and a surface, as limited by available friction; when this is the case, traction is often expressed as the ratio of the maximum tractive force to the normal force and is termed the coefficient of traction (similar to coefficient of friction).
Figure 2: Weight (W), the frictional force (F r), and the normal force (F n) acting on a block.Weight is the product of mass (m) and the acceleration of gravity (g).In the case of an object resting upon a flat table (unlike on an incline as in Figures 1 and 2), the normal force on the object is equal but in opposite direction to the gravitational force applied on the object (or the weight of ...
For the thin-walled assumption to be valid, the vessel must have a wall thickness of no more than about one-tenth (often cited as Diameter / t > 20) of its radius. [4] This allows for treating the wall as a surface, and subsequently using the Young–Laplace equation for estimating the hoop stress created by an internal pressure on a thin-walled cylindrical pressure vessel:
In Wenzel state, adding surface roughness will enhance the wettability caused by the chemistry of the surface. The Wenzel correlation can be written as = where θ m is the measured contact angle, θ Y is the Young contact angle and r is the roughness ratio. The roughness ratio is defined as the ratio between the actual and projected ...
If the normal unit vector n of the surface (pointing from Q towards P) is assumed fixed, the normal component can be expressed by a single number, the dot product T · n. This number will be positive if P is "pulling" on Q (tensile stress), and negative if P is "pushing" against Q (compressive stress).