Search results
Results from the WOW.Com Content Network
In computer science, a circular buffer, circular queue, cyclic buffer or ring buffer is a data structure that uses a single, fixed-size buffer as if it were connected end-to-end. This structure lends itself easily to buffering data streams. [1] There were early circular buffer implementations in hardware. [2] [3]
Representation of a FIFO queue. In computing and in systems theory, first in, first out (the first in is the first out), acronymized as FIFO, is a method for organizing the manipulation of a data structure (often, specifically a data buffer) where the oldest (first) entry, or "head" of the queue, is processed first.
A Standard Test and Programming Language is defined by JEDEC standard JESD-71 for JTAG programming of PLD's. Many MIPS and PowerPC processors have JTAG support Intel Core, Xeon, Atom, and Quark processors all support JTAG probe mode with Intel-specific extensions of JTAG using the so-called 60-pin eXtended Debug Port [XDP].
Early versions have a broken FIFO buffer and therefore cannot safely run any faster than the 16450 UART. [14] Versions of this UART that were not broken have 32-character FIFO buffers and could function at standard serial port speeds up to 230.4 kbit/s if the operating system has a 1 millisecond interrupt latency.
An on-chip FIFO buffer for both incoming and outgoing data; this gives the host system more time to respond to an interrupt generated by the UART, without loss of data. Both the computer hardware and software interface of the 16550 are backward compatible with the earlier 8250 UART and 16450 UART .
Since 2012, Xilinx ISE has been discontinued in favor of Vivado Design Suite that serves the same roles as ISE with additional features for system on a chip development. [8] [9] Xilinx released the last version of ISE in October 2013 (version 14.7), and states that "ISE has moved into the sustaining phase of its product life cycle, and there are no more planned ISE releases."
Verilog was later submitted to IEEE and became IEEE Standard 1364-1995, commonly referred to as Verilog-95. In the same time frame Cadence initiated the creation of Verilog-A to put standards support behind its analog simulator Spectre. Verilog-A was never intended to be a standalone language and is a subset of Verilog-AMS which encompassed ...
The loop counter is used to decide when the loop should terminate and for the program flow to continue to the next instruction after the loop. A common identifier naming convention is for the loop counter to use the variable names i , j , and k (and so on if needed), where i would be the most outer loop, j the next inner loop, etc.