enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Rocker arm - Wikipedia

   en.wikipedia.org/wiki/Rocker_arm

   The rocker ratio is the distance travelled by the valve divided by the distance travelled by the pushrod effective. The ratio is determined by the ratio of the distances from the rocker arm's pivot point to the point where it touches the valve and the point where it touches the pushrod/camshaft.

3. Pull-rod suspension - Wikipedia

   en.wikipedia.org/wiki/Pull-rod_suspension

   As such, push-rod suspension systems allow for much greater high-speed stability, much lower levels of body-roll, and a much lower centre of gravity for the vehicle. [7] For pull-rod suspension systems, the only difference is the orientation of the rocker arms. In a push-rod system, the rocker arms are placed at the highest point in the assembly.

4. Master cylinder - Wikipedia

   en.wikipedia.org/wiki/Master_cylinder

   The most common vehicle uses of master cylinders are in brake and clutch systems.. In brake systems, the operated devices are cylinders inside brake calipers and/or drum brakes; these cylinders may be called wheel cylinders or slave cylinders, and they push the brake pads towards a surface that rotates with the wheel (this surface is typically either a drum or a disc, a.k.a. a rotor) until the ...

5. Crankpin - Wikipedia

   en.wikipedia.org/wiki/Crankpin

   The crankpin connects to the larger end of the connecting rod for each cylinder. This end of the connecting rod is called the "big end", as opposed to the "small end" or "little end" (which connects to the wrist/gudgeon pin in the piston). The bearing which allows the crankpin to rotate around its shaft is called the "rod bearing". [5]

6. Multi-valve - Wikipedia

   en.wikipedia.org/wiki/Multi-valve

   A cylinder head of a four valve Nissan VQ engine engine. A multi-valve or multivalve engine is one where each cylinder has more than two valves (an intake, and an exhaust).A multi-valve engine has better breathing, and with more smaller valves (having less mass in motion) may be able to operate at higher revolutions per minute (RPM) than a two-valve engine, delivering more power.

7. Gasket - Wikipedia

   en.wikipedia.org/wiki/Gasket

   A flange gasket is a type of gasket made to fit between two sections of pipe that are flared to provide higher surface area. Flange gaskets come in a variety of sizes and are categorized by their inside diameter and their outside diameter. There are many standards in gasket for flanges of pipes.