Search results
Results from the WOW.Com Content Network
Density system unit unit-code symbol or abbrev. notes sample default conversion combination output units Metric: kilogram per cubic metre: kg/m3 kg/m 3: 1.0 kg/m 3 (1.7 lb/cu yd)
The scale is a value or expression that is used as a factor to convert a value to its corresponding base unit. Commas may be used as a thousand separator (e.g. 1,000,000 ) or e notation may be used (e.g. 1e6 ).
The high molecular weight makes it a very tough material, but results in less efficient packing of the chains into the crystal structure as evidenced by densities of less than high-density polyethylene (for example, 0.930–0.935 g/cm 3). UHMWPE can be made through any catalyst technology, although Ziegler catalysts are most common.
In engineering and physics, g c is a unit conversion factor used to convert mass to force or vice versa. [1] It is defined as = In unit systems where force is a derived unit, like in SI units, g c is equal to 1.
Young's modulus per density; specific stiffness (10 6 m 2 s −2) Young's modulus per density squared (10 3 m 5 kg −1 s −2) Young's modulus per density cubed (m 8 kg −2 s −2) Reference Latex foam, low density, 10% compression [4] 5.9 × 10 ^ −7: 0.06: 9.83 × 10 ^ −6: 0.000164: 0.00273: Reversible Assembled Cellular Composite ...
The kilogram per cubic metre (symbol: kg·m −3, or kg/m 3) is the unit of density in the International System of Units (SI). It is defined by dividing the SI unit of mass, the kilogram, by the SI unit of volume, the cubic metre. [1]
HDPE is known for its high strength-to-density ratio. [4] The density of HDPE ranges from 930 to 970 kg/m 3. [5] Although the density of HDPE is only marginally higher than that of low-density polyethylene, HDPE has little branching, giving it stronger intermolecular forces and tensile strength (38 MPa versus 21 MPa) than LDPE. [6]
Typical densities are 29 to 120 kg/m 3 (49 to 202 lb/cu yd) with the lower figure being common. [1] Densities as low as 14 kg/m 3 (24 lb/cu yd) can be produced. [2] Base polymer for EPE foams range from Low-density polyethylene (LDPE) to High-density polyethylene (HDPE). [2]