Search results
Results from the WOW.Com Content Network
Vintage wooden bobbins, cylindrical, empty of wound fiber, dimensions 16 in. high by 9 in. in diameter. Vintage wooden bobbin, unflanged, wound with yarn and attached to a "shuttle" that fits it for use in a floor loom. A bobbin or spool is a spindle or cylinder, with or without flanges, on which yarn, thread, wire, tape or film is wound. [1]
A spring pin (also called tension pin or roll pin) is a mechanical fastener that secures the position of two or more parts of a machine relative to each other. Spring pins have a body diameter which is larger than the diameter of the hole they are intended for, and a chamfer on either one or both ends to facilitate starting the pin into the ...
Keeping the air flowing correctly through a wood-burning stove is essential for safe and efficient operation of the stove. Fresh air needs to enter the firebox to provide oxygen for the fire; as the fire burns, the smoke must be allowed to rise through the stove pipe, creating negative pressure in the firebox, and exit through the chimney.
A potbelly stove is a cast-iron, coal-burning or wood-burning stove that is cylindrical with a bulge in the middle. [1] The name is derived from the resemblance of the stove to a fat person's pot belly. Potbelly stoves were used to heat large rooms and were often found in train stations or one-room schoolhouses. The flat top of the stove allows ...
Orangeburg pipe (also known as "fiber conduit", "bituminous fiber pipe" or "Bermico" or "sand pipe") is bituminized fiber pipe used in the United States. It is made from layers of ground wood pulp fibers and asbestos fibres compressed with and bound by a water resistant adhesive then impregnated with liquefied coal tar pitch .
Ordinarily the allowance per inch decreases as the diameter increases; thus the total allowance for a diameter of 2 inches (50.8 mm) might be 0.004 inches (0.1016 mm), 0.2%), whereas for a diameter of 8 inches (203.2 mm) the total allowance might not be over 0.009 or 0.010 inches (0.2286 or 0.2540 mm) i.e., 0.11–0.12%).
One end is pierced for the string; the other is squared off to fit in a tuning lever socket. The middle section, which would pass through the wood, is tapered. A variety of methods are used to tune different stringed instruments. Most change the pitch produced when the string is played by adjusting the tension of the strings.
A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect