Search results
Results from the WOW.Com Content Network
English: a ruler from 0 to 1 inch (in.) in 1/32 inch divisions below the line and 1/2 millimetre (mm) divisions above the line to give a visual representation of the approximations. Principally designed to help visually determine if a metric or imperial drill bit will suffice.
For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use. From 1893, the foot was legally defined as exactly 1200 ⁄ 3937 m (approximately 0.304 8006 m). [13] Since July 1, 1959, the units of length have been defined on the basis of 1 yd = 0.9144 ...
A board foot is a United States and Canadian unit of approximate volume, used for lumber. It is equivalent to 1 inch × 1 foot × 1 foot (144 cu in or 2,360 cm 3). It is also found in the unit of density pounds per board foot. In Australia and New Zealand the terms super foot or superficial foot were formerly used for this unit. The exact ...
A scale ruler is a tool for measuring lengths and transferring measurements at a fixed ratio of length; two common examples are an architect's scale and engineer's scale.In scientific and engineering terminology, a device to measure linear distance and create proportional linear measurements is called a scale.
Under the Harappan linear measures, Indus cities during the Bronze Age used a foot of 13.2 inches (335 mm) and a cubit of 20.8 inches (528 mm). [11] The Egyptian equivalent of the foot—a measure of four palms or 16 digits—was known as the djeser and has been reconstructed as about 30 cm (11.8 in).
1.75 m – (5 feet 8 inches) – height of average U.S. male human as of 2002 (source: U.S. CDC as per female above) 2.4 m – wingspan of a mute swan; 2.5 m – height of a sunflower; 2.7 m – length of a leatherback sea turtle, the largest living turtle; 2.72 m – (8 feet 11 inches) – tallest-known human (Robert Wadlow) [31]
A ruler, depicting two customary units of length, the centimeter and the inch. A unit of length refers to any arbitrarily chosen and accepted reference standard for measurement of length. The most common units in modern use are the metric units, used in every country globally.
The international standard symbol for inch is in (see ISO 31-1, Annex A) but traditionally the inch is denoted by a double prime, which is often approximated by a double quote symbol, and the foot by a prime, which is often approximated by an apostrophe. For example; three feet, two inches can be written as 3 ′ 2″.