Search results
Results from the WOW.Com Content Network
When talking about circuit bit rates, people will interchangeably use the terms throughput, bandwidth and speed, and refer to a circuit as being a '64 k' circuit, or a '2 meg' circuit — meaning 64 kbit/s or 2 Mbit/s (see also the List of connection bandwidths). However, a '64 k' circuit will not transmit a '64 k' file in one second.
Throughput is usually measured in bits per second (bit/s, sometimes abbreviated bps), and sometimes in packets per second (p/s or pps) or data packets per time slot. The system throughput or aggregate throughput is the sum of the data rates that are delivered over all channels in a network. [1]
The packet transmission time in seconds can be obtained from the packet size in bit and the bit rate in bit/s as: Packet transmission time = Packet size / Bit rate. Example: Assuming 100 Mbit/s Ethernet, and the maximum packet size of 1526 bytes, results in Maximum packet transmission time = 1526×8 bit / (100 × 10 6 bit/s) ≈ 122 μs
Throughput is the actual rate that information is transferred Latency the delay between the sender and the receiver decoding it, this is mainly a function of the signals travel time, and processing time at any nodes the information traverses
Using Little's Law, one can calculate throughput with the equation: = where: I is the number of units contained within the system, inventory; T is the time it takes for all the inventory to go through the process, flow time; R is the rate at which the process is delivering throughput, flow rate or throughput.
rates the fairness of a set of values where there are users, is the throughput for the th connection, and ^ is the sample coefficient of variation. The result ranges from 1 n {\displaystyle {\tfrac {1}{n}}} (worst case) to 1 (best case), and it is maximum when all users receive the same allocation.
The goodput is a ratio between delivered amount of information, and the total delivery time. This delivery time includes: Inter-packet time gaps caused by packet generation processing time (a source that does not use the full network capacity), or by protocol timing (for example collision avoidance)
The ISQ symbols for the bit and byte are bit and B, respectively.In the context of data-rate units, one byte consists of 8 bits, and is synonymous with the unit octet.The abbreviation bps is often used to mean bit/s, so that when a 1 Mbps connection is advertised, it usually means that the maximum achievable bandwidth is 1 Mbit/s (one million bits per second), which is 0.125 MB/s (megabyte per ...