Search results
Results from the WOW.Com Content Network
Ethernet Routing Switch 5600 Series or (ERS 5600) in computer networking terms are stackable routers and switches designed and manufactured by Avaya.The ERS 5600 Switches can be stacked up to 8 units high to create a 1.152 Tbit/s backplane [1] [2] through the Flexible Advanced Stacking Technology (FAST) stacking technology [3] [4] configuration.
Supermicro AOC-SGP-I2 dual-port Gigabit Ethernet NIC, a PCI Express ×4 card. 1000BASE-T (also known as IEEE 802.3ab) is a standard for Gigabit Ethernet over twisted-pair wiring. Each 1000BASE-T network segment is recommended to be a maximum length of 100 meters (330 feet), [5] [a] and must use Category 5 cable or better (including Cat 5e and ...
The Cisco 12000, also known as a Gigabit Switch Router or GSR, is a series of large network routers designed and manufactured by Cisco Systems. [ 1 ] IP Services Engine (ISE) with four Gigabit Ethernet SFPs on the left.
The PCI-X standard was developed jointly by IBM, HP, and Compaq and submitted for approval in 1998. It was an effort to codify proprietary server extensions to the PCI local bus to address several shortcomings in PCI, and increase performance of high bandwidth devices, such as Gigabit Ethernet, Fibre Channel, and Ultra3 SCSI cards, and allow processors to be interconnected in clusters.
F_Port (Fabric port) An F_Port is a switch port that is connected to an N_Port. [14] E_Port (Expansion port) Switch port that attaches to another E_Port to create an Inter-Switch Link. [14] Fibre Channel Loop protocols create multiple types of Loop Ports: L_Port (Loop port) FC_Port that contains Arbitrated Loop functions associated with the ...
The base page is sufficient for devices to advertise which ones among the 10BASE-T, 100BASE-TX and 100BASE-T4 modes they support. For gigabit Ethernet, two other pages are required. These pages are sent if both devices have sent base pages with a next page bit set to one. The additional pages are of two kinds: message pages and unformatted ...
The competing MGBASE-T Alliance, stating the same faster Gigabit Ethernet objectives, was founded in December 2014. [15] In contrast to NBASE-T, the MGBASE-T said that their specifications would be open source. [16] IEEE 802.3's "2.5G/5GBASE-T Task Force" started working on the 2.5GBASE-T and 5GBASE-T standards in March 2015. [17]
For example, on the original IBM PC, a male D-sub was an RS-232-C DTE port (with a non-standard current loop interface on reserved pins), but the female D-sub connector on the same PC model was used for the parallel "Centronics" printer port. Some personal computers put non-standard voltages or signals on some pins of their serial ports.