enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Shear (sheet metal) - Wikipedia

   en.wikipedia.org/wiki/Shear_(sheet_metal)

   An alligator shear, historically known as a lever shear and sometimes as a crocodile shear, is a metal-cutting shear with a hinged jaw, powered by a flywheel or hydraulic cylinder. Alligator shears are generally set up as stand-alone shears; however, there are types for excavators. The jaw size can range from 4 to 36 in (100 to 910 mm) long.

3. Husky (tool brand) - Wikipedia

   en.wikipedia.org/wiki/Husky_(tool_brand)

   Husky is a line of hand tools, pneumatic tools, and tool storage products. Though founded in 1924, it is now best known as the house brand of The Home Depot, where it is exclusively sold. Its hand tools are manufactured for Home Depot by Western Forge, Apex Tool Group, and Iron Bridge Tools. [1] Its slogan is "The toughest name in tools."

4. Snips - Wikipedia

   en.wikipedia.org/wiki/Snips

   Snips, also known as shears, are hand tools used to cut sheet metal and other tough webs. It is a cutting tool. Workers use various types of snips, with the cutting edges being straight or curved to various degrees. The style of edge employed will depend if a straight sheer or some type of shapes cut is necessary.

5. Category:Metalworking cutting tools - Wikipedia

   en.wikipedia.org/wiki/Category:Metalworking...

   Cutting tool (machining) D. Diamond segment; ... Shear (sheet metal) Shearing (manufacturing) Sutton Tools; T. Snips; Tipped tool; Tool bit; W. Water jet cutter; Wire saw

6. Types of press tools - Wikipedia

   en.wikipedia.org/wiki/Types_of_press_tools

   Blanking is the operation of cutting flat shapes from sheet metal. The outer area of metal remaining after a blanking operation is generally discarded as waste. Size of blank or product is the size of the die & clearance is given on punch. It is a metal cutting operation. In blanking, metal obtained after cutting is not a scrap if it is usable.

7. Nibbler - Wikipedia

   en.wikipedia.org/wiki/Nibbler

   A nibbler, or nibblers, [1] is a tool for cutting sheet metal with minimal distortion. They may be used for nibbling. One type operates much like a punch and die, with a blade that moves in a linear fashion against a fixed die, removing small bits of metal and leaving a kerf approximately 6 mm (0.24 in) wide. Another type operates similar to ...