Search results
Results from the WOW.Com Content Network
A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete. Steel- reinforced slabs, typically between 100 and 500 mm thick, are most often used to construct floors and ceilings, while thinner mud slabs may be used for exterior paving ( see below ).
TU/e Built Environment's Rohaco 3D Concrete Printer being extensively used for Concrete Printing Research. 3D concrete printing, or simply concrete printing, refers to digital fabrication processes for cementitious materials based on one of several different 3D printing technologies. 3D-printed concrete eliminates the need for formwork, reducing material waste and allowing for greater ...
Slabs are one of the greatest consumers of concrete in many buildings, [14] so reducing the slab mass can make a relatively large difference to the environmental impact of a building's construction. Biaxial slabs may be marginally cheaper than solid slabs, partly due to the lower mass.
Early construction 3D printing development and research have been under way since 1995. Two methods were invented, one by Joseph Pegna [9] which was focused on a sand/cement forming technique which utilized steam to selectively bond the material in layers or solid parts, though this technique was never demonstrated.
Tilt-up, tilt-slab or tilt-wall is a type of building and a construction technique using concrete. Though it is a cost-effective technique with a shorter completion time, [ 1 ] poor performance in earthquakes has mandated significant seismic retrofit requirements in older buildings.
The precast concrete slab has tubular voids extending the full length of the slab, typically with a diameter equal to the 2/3–3/4 the thickness of the slab. This makes the slab much lighter than a massive solid concrete floor slab of equal thickness or strength. The reduced weight also lowers material and transportation costs.
Lift slab construction (also called the Youtz-Slick Method) is a method of constructing concrete buildings by casting the floor or roof slab on top of the previous slab and then raising (jacking) the slab up with hydraulic jacks. This method of construction allows for a large portion of the work to be completed at ground level, negating the ...
Reinforcement bars are pre-installed, just like in the case of conventionally cast concrete, and the rheology of the concrete is adapted to retain the shape of the slipforming formwork before concrete hydrates enough to sustain self-weight. [14] Concrete facade mullions of varying cross-sections are produced for a DFAB house [15] in Switzerland.