Search results
Results from the WOW.Com Content Network
A thrust block, also known as a thrust box, is a specialised form of thrust bearing used in ships, to resist the thrust of the propeller shaft and transmit it to the hull. Early thrust boxes [ edit ]
The rigid frame supports were inclined welded steel legs resting on reinforced concrete thrust blocks. The structural steel in the bridge and its inclined supports was not coated, as the weathering steel used was designed to develop a protective patina over time.
The keel blocks in the drydock were set up especially to support this curve. During her three years in drydock, the center keel blocks were gradually shortened, allowing the hog to settle out. Additionally, the diagonal riders specified in her original design to resist hogging, which had been removed in an earlier refit, were restored.
Large Xblocs (8.0 m 3 or 280 cu ft) on a trial placement area. An Xbloc is a wave-dissipating concrete block (or "armour unit") designed to protect shores, harbour walls, seawalls, breakwaters and other coastal structures from the direct impact of incoming waves.
The ultimate strength of concrete is influenced by the water-cementitious ratio (w/cm), the design constituents, and the mixing, placement and curing methods employed.All things being equal, concrete with a lower water-cement (cementitious) ratio makes a stronger concrete than that with a higher ratio. [2]
Strength depends upon material properties. The strength of a material depends on its capacity to withstand axial stress, shear stress, bending, and torsion.The strength of a material is measured in force per unit area (newtons per square millimetre or N/mm², or the equivalent megapascals or MPa in the SI system and often pounds per square inch psi in the United States Customary Units system).
The actual resolution of forces will depend upon the bridge' design. [1] If no horizontal thrusting forces are generated, this becomes an arch-shaped truss which is essentially a bent beam – see moon bridge for an example. If horizontal thrust is generated but the apex of the arch is a pin joint, this is termed as a three-hinged arch.
Concrete water pipe Connecting to an existing water line (white pipe) with a stainless steel tapping sleeve and valve (red). A concrete thrust block is being formed behind the new connection.